1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
|
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2017 Allied Telesis Labs
*/
#include <common.h>
#include <command.h>
#include <dm.h>
#include <env.h>
#include <i2c.h>
#include <wdt.h>
#include <asm/gpio.h>
#include <linux/mbus.h>
#include <linux/io.h>
#include <asm/arch/cpu.h>
#include <asm/arch/soc.h>
#include "../common/gpio_hog.h"
#include "../drivers/ddr/marvell/a38x/ddr3_init.h"
#include <../serdes/a38x/high_speed_env_spec.h>
DECLARE_GLOBAL_DATA_PTR;
#define MVEBU_DEV_BUS_BASE (MVEBU_REGISTER(0x10400))
#define CONFIG_NVS_LOCATION 0xf4800000
#define CONFIG_NVS_SIZE (512 << 10)
static struct serdes_map board_serdes_map[] = {
{PEX0, SERDES_SPEED_5_GBPS, PEX_ROOT_COMPLEX_X1, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{PEX1, SERDES_SPEED_5_GBPS, PEX_ROOT_COMPLEX_X1, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0}
};
int hws_board_topology_load(struct serdes_map **serdes_map_array, u8 *count)
{
*serdes_map_array = board_serdes_map;
*count = ARRAY_SIZE(board_serdes_map);
return 0;
}
/*
* Define the DDR layout / topology here in the board file. This will
* be used by the DDR3 init code in the SPL U-Boot version to configure
* the DDR3 controller.
*/
static struct mv_ddr_topology_map board_topology_map = {
DEBUG_LEVEL_ERROR,
0x1, /* active interfaces */
/* cs_mask, mirror, dqs_swap, ck_swap X PUPs */
{ { { {0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0} },
SPEED_BIN_DDR_1866M, /* speed_bin */
MV_DDR_DEV_WIDTH_16BIT, /* sdram device width */
MV_DDR_DIE_CAP_4GBIT, /* die capacity */
MV_DDR_FREQ_SAR, /* frequency */
0, 0, /* cas_l cas_wl */
MV_DDR_TEMP_LOW, /* temperature */
MV_DDR_TIM_2T} }, /* timing */
BUS_MASK_32BIT_ECC, /* subphys mask */
MV_DDR_CFG_DEFAULT, /* ddr configuration data source */
{ {0} }, /* raw spd data */
{0}, /* timing parameters */
{ {0} }, /* electrical configuration */
{0}, /* electrical parameters */
0, /* Clock enable mask */
160 /* Clock delay */
};
struct mv_ddr_topology_map *mv_ddr_topology_map_get(void)
{
/* Return the board topology as defined in the board code */
return &board_topology_map;
}
int board_early_init_f(void)
{
/* Configure MPP */
writel(0x00001111, MVEBU_MPP_BASE + 0x00);
writel(0x00000000, MVEBU_MPP_BASE + 0x04);
writel(0x55000000, MVEBU_MPP_BASE + 0x08);
writel(0x55550550, MVEBU_MPP_BASE + 0x0c);
writel(0x55555555, MVEBU_MPP_BASE + 0x10);
writel(0x00100565, MVEBU_MPP_BASE + 0x14);
writel(0x40000000, MVEBU_MPP_BASE + 0x18);
writel(0x00004444, MVEBU_MPP_BASE + 0x1c);
return 0;
}
void spl_board_init(void)
{
}
int board_init(void)
{
/* address of boot parameters */
gd->bd->bi_boot_params = mvebu_sdram_bar(0) + 0x100;
/* window for NVS */
mbus_dt_setup_win(&mbus_state, CONFIG_NVS_LOCATION, CONFIG_NVS_SIZE,
CPU_TARGET_DEVICEBUS_BOOTROM_SPI, CPU_ATTR_DEV_CS1);
/* DEV_READYn is not needed for NVS, ignore it when accessing CS1 */
writel(0x00004001, MVEBU_DEV_BUS_BASE + 0xc8);
spl_board_init();
return 0;
}
void arch_preboot_os(void)
{
#ifdef CONFIG_WATCHDOG
wdt_stop(gd->watchdog_dev);
#endif
}
static int led_7seg_init(unsigned int segments)
{
int node;
int ret;
int i;
struct gpio_desc desc[8];
node = fdt_node_offset_by_compatible(gd->fdt_blob, 0,
"atl,of-led-7seg");
if (node < 0)
return -ENODEV;
ret = gpio_request_list_by_name_nodev(offset_to_ofnode(node),
"segment-gpios", desc,
ARRAY_SIZE(desc), GPIOD_IS_OUT);
if (ret < 0)
return ret;
for (i = 0; i < ARRAY_SIZE(desc); i++) {
ret = dm_gpio_set_value(&desc[i], !(segments & BIT(i)));
if (ret)
return ret;
}
return 0;
}
#ifdef CONFIG_MISC_INIT_R
int misc_init_r(void)
{
static struct gpio_desc usb_en = {}, nand_wp = {}, phy_reset[2] = {},
led_en = {};
gpio_hog(&usb_en, "atl,usb-enable", "enable-gpio", 1);
gpio_hog(&nand_wp, "atl,nand-protect", "protect-gpio", 1);
gpio_hog_list(phy_reset, ARRAY_SIZE(phy_reset), "atl,phy-reset", "reset-gpio", 0);
gpio_hog(&led_en, "atl,led-enable", "enable-gpio", 1);
#ifdef MTDPARTS_MTDOOPS
env_set("mtdoops", MTDPARTS_MTDOOPS);
#endif
led_7seg_init(0xff);
return 0;
}
#endif
#ifdef CONFIG_DISPLAY_BOARDINFO
int checkboard(void)
{
puts("Board: " CONFIG_SYS_BOARD "\n");
return 0;
}
#endif
|
