/* * (C) Copyright 2004 * Texas Instruments. * Richard Woodruff * Kshitij Gupta * * Configuration settings for the phyCORE-i.MX31 board. * * SPDX-License-Identifier: GPL-2.0+ */ #ifndef __CONFIG_H #define __CONFIG_H #include /* High Level Configuration Options */ #define CONFIG_MX31 /* This is a mx31 */ #define CONFIG_MX31_CLK32 32000 #define CONFIG_CMDLINE_TAG /* enable passing of ATAGs */ #define CONFIG_SETUP_MEMORY_TAGS #define CONFIG_INITRD_TAG /* * Size of malloc() pool */ #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 512 * 1024) /* * Hardware drivers */ #define CONFIG_SYS_I2C #define CONFIG_SYS_I2C_MXC #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */ #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */ #define CONFIG_SYS_I2C_MXC_I2C3 /* enable I2C bus 3 */ #define CONFIG_SYS_I2C_CLK_OFFSET I2C2_CLK_OFFSET #define CONFIG_MXC_UART #define CONFIG_MXC_UART_BASE UART1_BASE /* allow to overwrite serial and ethaddr */ #define CONFIG_ENV_OVERWRITE /*********************************************************** * Command definition ***********************************************************/ #define CONFIG_NETMASK 255.255.255.0 #define CONFIG_IPADDR 192.168.23.168 #define CONFIG_SERVERIP 192.168.23.2 #define CONFIG_EXTRA_ENV_SETTINGS \ "bootargs_base=setenv bootargs console=ttySMX0,115200\0" \ "bootargs_nfs=setenv bootargs $(bootargs) root=/dev/nfs " \ "ip=dhcp nfsroot=$(serverip):$(nfsrootfs),v3,tcp\0" \ "bootargs_flash=setenv bootargs $(bootargs) " \ "root=/dev/mtdblock2 rootfstype=jffs2\0" \ "bootargs_mtd=setenv bootargs $(bootargs) $(mtdparts)\0" \ "bootcmd=run bootcmd_net\0" \ "bootcmd_net=run bootargs_base bootargs_mtd bootargs_nfs;" \ "tftpboot 0x80000000 $(uimage);bootm\0" \ "bootcmd_flash=run bootargs_base bootargs_mtd bootargs_flash;" \ "bootm 0x80000000\0" \ "unlock=yes\0" \ "mtdparts=" CONFIG_MTDPARTS_DEFAULT "\0" \ "prg_uboot=tftpboot 0x80000000 $(uboot);" \ "protect off 0xa0000000 +0x20000;" \ "erase 0xa0000000 +0x20000;" \ "cp.b 0x80000000 0xa0000000 $(filesize)\0" \ "prg_kernel=tftpboot 0x80000000 $(uimage);" \ "erase 0xa0040000 +0x180000;" \ "cp.b 0x80000000 0xa0040000 $(filesize)\0" \ "prg_jffs2=tftpboot 0x80000000 $(jffs2);" \ "erase 0xa01c0000 0xa1ffffff;" \ "cp.b 0x80000000 0xa01c0000 $(filesize)\0" \ "videomode=video=ctfb:x:240,y:320,depth:16,mode:0," \ "pclk:185925,le:9,ri:17,up:7,lo:10,hs:1,vs:1," \ "sync:1241513985,vmode:0\0" /* * Miscellaneous configurable options */ #define CONFIG_SYS_MEMTEST_START 0 /* memtest works on */ #define CONFIG_SYS_MEMTEST_END 0x10000 #define CONFIG_SYS_LOAD_ADDR 0 /* default load address */ /* * Physical Memory Map */ #define CONFIG_NR_DRAM_BANKS 1 #define PHYS_SDRAM_1 0x80000000 #define PHYS_SDRAM_1_SIZE (128 * 1024 * 1024) #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1 #define CONFIG_SYS_INIT_RAM_ADDR IRAM_BASE_ADDR #define CONFIG_SYS_INIT_RAM_SIZE IRAM_SIZE #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - \ GENERATED_GBL_DATA_SIZE) #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_INIT_RAM_ADDR + \ CONFIG_SYS_GBL_DATA_OFFSET) /* * FLASH and environment organization */ #define CONFIG_SYS_FLASH_BASE 0xa0000000 #define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max # of memory banks */ #define CONFIG_SYS_MAX_FLASH_SECT 259 /* max # of sectors/chip */ /* Monitor at beginning of flash */ #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE #define CONFIG_ENV_OFFSET 0x00 /* env. starts here */ #define CONFIG_ENV_SIZE 4096 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x52 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 5 /* 5 bits = 32 octets */ #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10 /* 10 ms delay */ #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2 /* byte addr. lenght */ /* * CFI FLASH driver setup */ #define CONFIG_SYS_FLASH_CFI /* Flash memory is CFI compliant */ #define CONFIG_FLASH_CFI_DRIVER /* Use drivers/mtd/cfi_flash.c */ #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE /* buffered writes (~10x faster) */ #define CONFIG_SYS_FLASH_PROTECTION /* Use hardware sector protection */ /* * Timeout for Flash Erase and Flash Write * timeout values are in ticks */ #define CONFIG_SYS_FLASH_ERASE_TOUT (100*CONFIG_SYS_HZ) #define CONFIG_SYS_FLASH_WRITE_TOUT (100*CONFIG_SYS_HZ) /* * JFFS2 partitions */ #define CONFIG_JFFS2_DEV "nor0" /* EET platform additions */ #ifdef CONFIG_TARGET_IMX31_PHYCORE_EET #define CONFIG_HARD_SPI #define CONFIG_S6E63D6 #define CONFIG_VIDEO_MX3 #define CONFIG_VIDEO_LOGO #define CONFIG_SPLASH_SCREEN #define CONFIG_BMP_16BPP #endif #endif /* __CONFIG_H */