From ba8ba69b66923362a379822d77a6e78c117721e1 Mon Sep 17 00:00:00 2001 From: Vabhav Sharma Date: Wed, 30 Jan 2019 11:24:00 +0000 Subject: drivers: serial: dm: Enable DM_FLAG_PRE_RELOC in SBSA pl011 uart driver The DM_FLAG_PRE_RELOC shall be enabled in SBSA PL011 uart driver as this driver is used in NXP based SoCs It is necessary to have Serial console running before relocation The !CONFIG_IS_ENABLED(OF_CONTROL) [*] check is set as "workaround" for DM problem : 4687919684e This flag is set if board does not support device-tree and using platform data, In DM Model either of device tree or platform data can be used to fetch device configuration It is possible to use SBSA UART with CONFIG_DM_SERIAL but witout corresponding device tree description (OF_CONTROL) Other board/SoCs have this flag set unconditionally Signed-off-by: Vabhav Sharma --- drivers/serial/serial_pl01x.c | 2 -- 1 file changed, 2 deletions(-) (limited to 'drivers/serial') diff --git a/drivers/serial/serial_pl01x.c b/drivers/serial/serial_pl01x.c index 12512f65782..2a5f256184f 100644 --- a/drivers/serial/serial_pl01x.c +++ b/drivers/serial/serial_pl01x.c @@ -363,9 +363,7 @@ U_BOOT_DRIVER(serial_pl01x) = { .platdata_auto_alloc_size = sizeof(struct pl01x_serial_platdata), .probe = pl01x_serial_probe, .ops = &pl01x_serial_ops, -#if !CONFIG_IS_ENABLED(OF_CONTROL) .flags = DM_FLAG_PRE_RELOC, -#endif .priv_auto_alloc_size = sizeof(struct pl01x_priv), }; -- cgit v1.2.3