From fdf8529afc39b9d096159b7d3287d7e29e51ec3a Mon Sep 17 00:00:00 2001 From: Ying Zhang Date: Fri, 16 Aug 2013 15:16:13 +0800 Subject: powerpc : spi flash : Support to start from eSPI with SPL This patch introduces SPL to enable a loader stub that being loaded by the code from the internal on-chip ROM. It loads the final uboot image into DDR, then jump to it to begin execution. The SPL's size is sizeable, the maximum size must not exceed the size of L2 SRAM. It initializes the DDR through SPD code, and copys final uboot image to DDR. So there are two stage uboot images: * spl_boot, 96KB size. The env variables are copied to L2 SRAM, so that ddr spd code can get the interleaving mode setting in env. It loads final uboot image from offset 96KB. * final uboot image, size is variable depends on the functions enabled. Signed-off-by: Ying Zhang Acked-by: York Sun --- drivers/mtd/spi/spi_flash.c | 2 ++ 1 file changed, 2 insertions(+) (limited to 'drivers/mtd/spi/spi_flash.c') diff --git a/drivers/mtd/spi/spi_flash.c b/drivers/mtd/spi/spi_flash.c index 9814395b93..5d5055ff38 100644 --- a/drivers/mtd/spi/spi_flash.c +++ b/drivers/mtd/spi/spi_flash.c @@ -555,12 +555,14 @@ struct spi_flash *spi_flash_probe(unsigned int bus, unsigned int cs, goto err_manufacturer_probe; } #endif +#ifndef CONFIG_SPL_BUILD printf("SF: Detected %s with page size ", flash->name); print_size(flash->sector_size, ", total "); print_size(flash->size, ""); if (flash->memory_map) printf(", mapped at %p", flash->memory_map); puts("\n"); +#endif #ifndef CONFIG_SPI_FLASH_BAR if (flash->size > SPI_FLASH_16MB_BOUN) { puts("SF: Warning - Only lower 16MiB accessible,"); -- cgit v1.2.3