From 947eb4396dfe11e89f0d3cafe755b395c6c0a8a2 Mon Sep 17 00:00:00 2001 From: Bin Meng Date: Mon, 27 Jul 2015 00:33:43 -0700 Subject: doc: dm: Update pci-info.txt for pci support Correct two typos and mention how pci bus will be probed. Signed-off-by: Bin Meng Acked-by: Simon Glass --- doc/driver-model/pci-info.txt | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'doc/driver-model') diff --git a/doc/driver-model/pci-info.txt b/doc/driver-model/pci-info.txt index 63efcb7b92..cf69167bd1 100644 --- a/doc/driver-model/pci-info.txt +++ b/doc/driver-model/pci-info.txt @@ -6,7 +6,7 @@ How busses are scanned Any config read will end up at pci_read_config(). This uses uclass_get_device_by_seq() to get the PCI bus for a particular bus number. -Bus number 0 will need to be requested first, and the alias in the device +Bus number 0 will need to be requested first, and the alias in the device tree file will point to the correct device: @@ -23,7 +23,7 @@ tree file will point to the correct device: If there is no alias the devices will be numbered sequentially in the device tree. -The call to uclass_get_device by seq() will cause the PCI bus to be probed. +The call to uclass_get_device() will cause the PCI bus to be probed. This does a scan of the bus to locate available devices. These devices are bound to their appropriate driver if available. If there is no driver, then they are bound to a generic PCI driver which does nothing. @@ -32,7 +32,7 @@ After probing a bus, the available devices will appear in the device tree under that bus. Note that this is all done on a lazy basis, as needed, so until something is -touched on PCI it will not be probed. +touched on PCI (eg: a call to pci_find_devices()) it will not be probed. PCI devices can appear in the device tree. If they do this serves to specify the driver to use for the device. In this case they will be bound at -- cgit v1.2.3