From a8011eb84dfac5187cebf00ed8bc981bdb5c1fa1 Mon Sep 17 00:00:00 2001 From: Olliver Schinagl Date: Wed, 21 Nov 2018 20:05:25 +0200 Subject: sunxi: board: Print error after power initialization fails Currently during init, we enable all power, then enable the dram and after that check whether there was an error during power-up. This makes little sense, we should enable power and then check if power was brought up properly before we continue to initialize other things. This patch moves the DRAM init after the power failure check. Signed-off-by: Olliver Schinagl Signed-off-by: Priit Laes Acked-by: Maxime Ripard --- board/sunxi/board.c | 18 ++++++++++-------- 1 file changed, 10 insertions(+), 8 deletions(-) (limited to 'board/sunxi') diff --git a/board/sunxi/board.c b/board/sunxi/board.c index 64ccbc7245..26284db111 100644 --- a/board/sunxi/board.c +++ b/board/sunxi/board.c @@ -637,13 +637,6 @@ void sunxi_board_init(void) power_failed |= axp_set_sw(IS_ENABLED(CONFIG_AXP_SW_ON)); #endif #endif - printf("DRAM:"); - gd->ram_size = sunxi_dram_init(); - printf(" %d MiB\n", (int)(gd->ram_size >> 20)); - if (!gd->ram_size) - hang(); - - sunxi_spl_store_dram_size(gd->ram_size); /* * Only clock up the CPU to full speed if we are reasonably @@ -652,7 +645,16 @@ void sunxi_board_init(void) if (!power_failed) clock_set_pll1(CONFIG_SYS_CLK_FREQ); else - printf("Failed to set core voltage! Can't set CPU frequency\n"); + printf("Error setting up the power controller.\n" + "CPU frequency not set.\n"); + + printf("DRAM:"); + gd->ram_size = sunxi_dram_init(); + printf(" %d MiB\n", (int)(gd->ram_size >> 20)); + if (!gd->ram_size) + hang(); + + sunxi_spl_store_dram_size(gd->ram_size); } #endif -- cgit v1.2.3