summaryrefslogtreecommitdiff
path: root/drivers
AgeCommit message (Collapse)Author
2008-01-0985xx: add ability to upload QE firmwareTimur Tabi
Define the layout of a binary blob that contains a QE firmware and instructions on how to upload it. Add function qe_upload_firmware() to parse the blob and perform the actual upload. Add command-line command "qe fw" to take a firmware blob in memory and upload it. Update ft_cpu_setup() on 85xx to create the 'firmware' device tree node if U-Boot has uploaded a firmware. Fully define 'struct rsp' in immap_qe.h to include the actual RISC Special Registers. Signed-off-by: Timur Tabi <timur@freescale.com>
2008-01-09fix various commentsMarcel Ziswiler
Signed-off-by: Marcel Ziswiler <marcel@ziswiler.com>
2008-01-09fix comments with new drivers organizationMarcel Ziswiler
Signed-off-by: Marcel Ziswiler <marcel@ziswiler.com>
2008-01-09Fix endianness conversions in rtl8169 driverGuennadi Liakhovetski
It is unclear on what platforms this driver has been tested, since noone up to now defines CONFIG_RTL8169 in the board configuration header. Now it has been fixed for a big-endian mpc8241 based linkstation platform. This patch presents the necessary endianness conversion fixes. Signed-off-by: Guennadi Liakhovetski <lg@denx.de>
2008-01-09Add Epson RX8025 RTC supportMatthias Fuchs
Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com>
2008-01-08Add support CONFIG_UEC_ETH3 in MPC83xxJoakim Tjernlund
Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
2008-01-08mpc83xx: Add the support of MPC837xEMDS boardDave Liu
The MPC837xEMDS board support: * DDR2 400MHz hardcoded and SPD init * Local bus NOR Flash * I2C, UART, MII and RTC * eTSEC RGMII * PCI host Signed-off-by: Dave Liu <daveliu@freescale.com>
2008-01-02cfi_flash: Fix bug in flash_isset() to use correct 32bit functionStefan Roese
This bug was detected on the LWMON5 target which has 2 Intel 16bit wide flash chips connected to a 32bit wide port. Signed-off-by: Stefan Roese <sr@denx.de>
2008-01-02Merge branch 'master' of git://www.denx.de/git/u-boot-cfi-flashWolfgang Denk
2007-12-27Merge branch 'master' of /home/stefan/git/u-boot/u-boot into for-1.3.2-ver2Stefan Roese
2007-12-27Add driver for National Semiconductor LM73 temperature sensorLarry Johnson
This driver is based on the driver for the LM75. Signed-off-by: Larry Johnson <lrj@acm.org>
2007-12-27Add driver for STMicroelectronics M41T60 RTCLarry Johnson
This driver is based on the driver for the M41T11. In the intended application, the RTC will be powered by a large capacitor, rather than a battery. The driver therefore checks to see whether the RTC has lost power. The chip's OUT bit is normally reset from its power-up state. If the OUT bit is read as set, or if the date and time are not valid, then the RTC is assumed to have lost power, and its date and time are reset to 1900-01-01 00:00:00. Support for adjusting the speed of the clock to improve accuracy is provided through an environment variable. Signed-off-by: Larry Johnson <lrj@acm.org>
2007-12-27cfi_flash: Add missing check for erased dest to flash_write_cfibuffer()Stefan Roese
The check for an sufficiently erased destination was missing in the buffered write function of the cfi flash driver (when CFG_FLASH_USE_BUFFER_WRITE is defined). This patch adds this check to that writing to such a region will fail with the currect error message. Signed-off-by: Stefan Roese <sr@denx.de>
2007-12-27Fix coding style issues; update CHANGELOG.Wolfgang Denk
Signed-off-by: Wolfgang Denk <wd@denx.de>
2007-12-27Merge branch 'master' of /home/wd/git/u-boot/custodiansWolfgang Denk
2007-12-27Merge branch 'master' of git://www.denx.de/git/u-boot-shWolfgang Denk
Conflicts: MAINTAINERS Signed-off-by: Wolfgang Denk <wd@denx.de>
2007-12-27Merge branch 'master' of git://www.denx.de/git/u-boot-mpc85xxWolfgang Denk
2007-12-17cfi_flash: Add manufacturer-specific fixupsHaavard Skinnemoen
Run fixups based on the JEDEC manufacturer ID independent of the command set ID. This changes current behaviour: Previously, geometry reversal for AMD chips were done based on the command set ID, while they are now done based on the JEDEC manufacturer and device ID. Also add fixup for top-boot Atmel chips. A fixup is needed for AT49BV6416(T) too, but since u-boot currently only reads the low byte of the device ID, there's no way to tell it apart from AT49BV642D, which should not have this fixup. Since AT49BV642D support is necessary to get ATNGW100 board support into mainline, I've commented out the fixup for now. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-17cfi_flash: Add cmdset-specific init functionsHaavard Skinnemoen
Move things like reading JEDEC IDs and fixing up geometry reversal into separate functions. The geometry reversal fixup is now performed by altering the qry structure directly, which makes the sector init code slightly cleaner. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-17cfi_flash: Read whole QRY structure in one goHaavard Skinnemoen
Read out the whole CFI Standard Query structure after successful cfi identification. This allows subsequent code to access this information directly without having to go through flash_read_uchar() and friends. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13cfi_flash: Use map_physmem() and unmap_physmem()Haavard Skinnemoen
Use map_physmem() and unmap_physmem() to convert from physical to virtual addresses. This gives the arch a chance to provide an uncached mapping for flash accesses. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13cfi_flash: Introduce read and write accessorsHaavard Skinnemoen
Introduce flash_read{8,16,32,64) and flash_write{8,16,32,64} and use them to access the flash memory. This makes it clearer when the flash is actually being accessed; merely dereferencing a volatile pointer looks just like any other kind of access. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13cfi_flash: Reorder functions and eliminate extra prototypesHaavard Skinnemoen
Reorder the functions in cfi_flash.c so that each function only uses functions that have been defined before it. This allows the static prototype declarations near the top to be eliminated and might allow gcc to do a better job inlining functions. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13cfi_flash: Make some needlessly global functions staticHaavard Skinnemoen
Make functions not declared in any header file static. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13cfi_flash: Break long linesHaavard Skinnemoen
This patch tries to keep all lines in the cfi_flash driver below 80 columns. There are a few lines left which don't fit this requirement because I couldn't find any trivial way to break them (i.e. it would take some restructuring, which I intend to do in a later patch.) Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-12-13CFI: synchronize command offsets with Linux CFI driverBartlomiej Sieka
Fixes non-working CFI Flash on the Inka4x0 board. Signed-off-by: Bartlomiej Sieka <tur@semihalf.com>
2007-12-11Handle MPC85xx PCIe reset errata (PCI-Ex 38)Kumar Gala
On the MPC85xx boards that have PCIe enable the PCIe errata fix. (MPC8544DS, MPC8548CDS, MPC8568MDS). Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2007-12-11rtc: Fix merging problemStefan Roese
Signed-off-by: Stefan Roese <sr@denx.de>
2007-12-11Merge commit 'u-boot/master' into for-1.3.1Stefan Roese
Conflicts: drivers/rtc/Makefile
2007-12-08CFI: Coding style cleanupStefan Roese
Signed-off-by: Stefan Roese <sr@denx.de>
2007-12-08CFI: support JEDEC flash roms in CFI-flash frameworkMichael Schwingen
The following patch adds support for non-CFI flash ROMS, by hooking into the CFI flash code and using most of its code, as recently discussed here in the thread "Mixing CFI and non-CFI flashs". Signed-off-by: Michael Schwingen <michael@schwingen.org> Signed-off-by: Stefan Roese <sr@denx.de>
2007-12-07sh: Moved driver of the SuperH dependenceNobuhiro Iwamatsu
The composition of the directory in the drivers/ changed. I moved SuperH serial driver and marubun PCMCIA driver. Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
2007-12-07Merge git://www.denx.de/git/u-bootNobuhiro Iwamatsu
Conflicts: drivers/Makefile
2007-11-29sh: Add marubun's pcmcia driverNobuhiro Iwamatsu
Marubun pcmcia is a chip for PCMCIA used with SuperH. Of course, this can be used even by other architectures. When use this driver, came to be able to use CompactFlash and Ethernet. Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
2007-11-29sh: Update SuperH SCIF driverNobuhiro Iwamatsu
- Changed volatile unsigned to vu_. - Changed Makefile for kconfig. Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
2007-11-29Merge git://www.denx.de/git/u-bootNobuhiro Iwamatsu
Conflicts: drivers/Makefile
2007-11-25drivers/mtd : move mtd drivers to drivers/mtdJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/misc : move misc drivers to drivers/miscJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/block : move block drivers to drivers/blockJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/rtc : move rtc drivers to drivers/rtcJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/hwmon : move hardware monitor drviers to drivers/hwmonJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/input : move input drivers to drivers/inputJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/usb : move usb drivers to drivers/usbJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/serial : move serial drivers to drivers/serialJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/net : move net drivers to drivers/netJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25drivers/video : move video drivers to drivers/videoJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-24drivers/pcmcia : move pcmcia drivers to drivers/pcmciaJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-24drivers/pci : move pci drivers to drivers/pciJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-20drivers/i2c : move i2c drivers to drivers/i2cJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-20Merge branch 'origin' into kconfig-for-1.3.1Grant Likely
generated by cgit v1.2.3 (git 2.0.4) at 2024-07-05 05:07:17 +0000