summaryrefslogtreecommitdiff
path: root/drivers
AgeCommit message (Expand)Author
2015-04-23Merge branch '2015.04-toradex-next-gpio' into 2015.04-toradex-nextStefan Agner
2015-04-23video: dcu: make sure memory size aligns to section sizeStefan Agner
2015-04-23video: dcu: add additional modes for DCUStefan Agner
2015-04-22dm: gpio: vf610: Add GPIO driver supportBhuvanchandra DV
2015-04-22dm: gpio: uclass: Add flag to control sequence numberingBhuvanchandra DV
2015-04-22ARM: vf610: add additional modes for DCUStefan Agner
2015-04-22video: dcu: fix framebuffer to the end of memoryStefan Agner
2015-04-22video: dcu: enable pixel clock after initializationStefan Agner
2015-04-21video: dcu: Add DCU support for Vybrid SoCStefan Agner
2015-04-15net: asix: fix operation without eepromMarcel Ziswiler
2015-04-15Revert "dm: tegra: Enable driver model for serial"Marcel Ziswiler
2015-04-15e1000: unprogrammed i210 operation hackMarcel Ziswiler
2015-04-14usb: host: Add ehci-vf USB driver for ARM Vybrid SoC'sSanchayan Maity
2015-04-14mtd: vf610_nfc: enable ONFI detectionStefan Agner
2015-04-14mtd: vf610_nfc: add 32-error correction option for HW ECCStefan Agner
2015-04-14mtd: vf610_nfc: add Freescale NFC controller configs to KconfigStefan Agner
2015-04-14mtd: vf610_nfc: use in-band bad block tableStefan Agner
2015-04-14mtd: vf610_nfc: implement OOB only readStefan Agner
2015-04-14mtd: vf610_nfc: allow bitflips in an empty pageStefan Agner
2015-04-14mtd: vf610_nfc: remove read on SEQINStefan Agner
2015-04-14mtd: vf610_nfc: remove caching of page in bufferStefan Agner
2015-04-10dtt: add ds620 supportAlbert ARIBAUD \(3ADEV\)
2015-04-10lpc32xx: add LPC32xx SSP support (SPI mode)Albert ARIBAUD \(3ADEV\)
2015-04-10lpc32xx: add GPIO supportAlbert ARIBAUD \(3ADEV\)
2015-04-10lpc32xx: i2c: add LPC32xx I2C interface supportAlbert ARIBAUD \(3ADEV\)
2015-04-10lpc32xx: mtd: nand: add MLC NAND controllerAlbert ARIBAUD \(3ADEV\)
2015-04-10lpc32xx: add Ethernet supportAlbert ARIBAUD \(3ADEV\)
2015-04-07ahci: Fix a wrong parameter passTang Yuantian
2015-04-06video: parade: configure SLP and RST GPIOs if specified in DTAjay Kumar
2015-04-06video: exynos_fb: configure backlight GPIOs if specified in DTAjay Kumar
2015-04-03serial-arc: switch to DMAlexey Brodkin
2015-04-03serial/serial_arc: set registers address during compilationAlexey Brodkin
2015-03-31Merge branch 'master' of git://git.denx.de/u-boot-atmelTom Rini
2015-04-01ARM: at91: atmel_nand: Support flash based BBTDavid Dueck
2015-03-31Merge git://git.denx.de/u-boot-nand-flashTom Rini
2015-03-31Merge branch 'master' of git://git.denx.de/u-boot-imxTom Rini
2015-03-30mtd: vf610_nfc: specify transfer size before each transferStefan Agner
2015-03-30mtd: vf610_nfc: mark page as dirty on block eraseStefan Agner
2015-03-30nand: yaffs: Remove the "nand write.yaffs" commandPeter Tyser
2015-03-30nand: Remove CONFIG_MTD_NAND_VERIFY_WRITEPeter Tyser
2015-03-30dfu: nand: Verify writesPeter Tyser
2015-03-30nand: Add verification functionsPeter Tyser
2015-03-30mtd: nand: mxs: fix PIO_WORDs in mxs_nand_write_buf()Luca Ellero
2015-03-30mtd: nand: mxs: fix PIO_WORDs in mxs_nand_read_buf()Luca Ellero
2015-03-30spi: designware_spi: revisit FIFO size detection againAxel Lin
2015-03-30spi: cf_spi: Staticize local functionsAxel Lin
2015-03-30spi: cf_spi: Use to_cf_spi_slave to resolve cfslave from slaveAxel Lin
2015-03-30qspi: dra7x: enable quad mode read for ti-qspi driverRavi Babu
2015-03-30spi: ftssp010_spi: Use to_ftssp010_spi() to ensure free correct addressAxel Lin
2015-03-30spi: davinci: Remove duplicate code to set bus and cs for slaveAxel Lin