diff options
Diffstat (limited to 'include/configs/ecovec.h')
| -rw-r--r-- | include/configs/ecovec.h | 133 |
1 files changed, 0 insertions, 133 deletions
diff --git a/include/configs/ecovec.h b/include/configs/ecovec.h deleted file mode 100644 index be03bf1627..0000000000 --- a/include/configs/ecovec.h +++ /dev/null @@ -1,133 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0+ */ -/* - * Configuation settings for the Renesas Solutions ECOVEC board - * - * Copyright (C) 2009 - 2011 Renesas Solutions Corp. - * Copyright (C) 2009 Kuninori Morimoto <morimoto.kuninori@renesas.com> - * Copyright (C) 2010, 2011 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> - */ - -#ifndef __ECOVEC_H -#define __ECOVEC_H - -/* - * Address Interface BusWidth - *----------------------------------------- - * 0x0000_0000 U-Boot 16bit - * 0x0004_0000 Linux romImage 16bit - * 0x0014_0000 MTD for Linux 16bit - * 0x0400_0000 Internal I/O 16/32bit - * 0x0800_0000 DRAM 32bit - * 0x1800_0000 MFI 16bit - */ - -#define CONFIG_CPU_SH7724 1 - -#define CONFIG_ECOVEC_ROMIMAGE_ADDR 0xA0040000 - -#define CONFIG_DISPLAY_BOARDINFO -#undef CONFIG_SHOW_BOOT_PROGRESS - -/* I2C */ -#define CONFIG_SYS_I2C -#define CONFIG_SYS_I2C_SH -#define CONFIG_SYS_I2C_SLAVE 0x7F -#define CONFIG_SYS_I2C_SH_NUM_CONTROLLERS 2 -#define CONFIG_SYS_I2C_SH_BASE0 0xA4470000 -#define CONFIG_SYS_I2C_SH_SPEED0 100000 -#define CONFIG_SYS_I2C_SH_BASE1 0xA4750000 -#define CONFIG_SYS_I2C_SH_SPEED1 100000 -#define CONFIG_SH_I2C_DATA_HIGH 4 -#define CONFIG_SH_I2C_DATA_LOW 5 -#define CONFIG_SH_I2C_CLOCK 41666666 - -/* Ether */ -#define CONFIG_SH_ETHER_USE_PORT (0) -#define CONFIG_SH_ETHER_PHY_ADDR (0x1f) -#define CONFIG_PHY_SMSC 1 -#define CONFIG_BITBANGMII -#define CONFIG_BITBANGMII_MULTI -#define CONFIG_SH_ETHER_PHY_MODE PHY_INTERFACE_MODE_MII - -/* USB / R8A66597 */ -#define CONFIG_USB_R8A66597_HCD -#define CONFIG_R8A66597_BASE_ADDR 0xA4D80000 -#define CONFIG_R8A66597_XTAL 0x0000 /* 12MHz */ -#define CONFIG_R8A66597_LDRV 0x8000 /* 3.3V */ -#define CONFIG_R8A66597_ENDIAN 0x0000 /* little */ -#define CONFIG_SUPERH_ON_CHIP_R8A66597 - -/* undef to save memory */ -/* Monitor Command Prompt */ -/* Buffer size for Console output */ -#define CONFIG_SYS_PBSIZE 256 -/* List of legal baudrate settings for this board */ -#define CONFIG_SYS_BAUDRATE_TABLE { 115200 } - -/* SCIF */ -#define CONFIG_SCIF 1 -#define CONFIG_CONS_SCIF0 1 - -/* Suppress display of console information at boot */ - -/* SDRAM */ -#define CONFIG_SYS_SDRAM_BASE (0x88000000) -#define CONFIG_SYS_SDRAM_SIZE (256 * 1024 * 1024) -#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) - -#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE) -#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + 200 * 1024 * 1024) -/* Enable alternate, more extensive, memory test */ -/* Scratch address used by the alternate memory test */ -#undef CONFIG_SYS_MEMTEST_SCRATCH - -/* Enable temporary baudrate change while serial download */ -#undef CONFIG_SYS_LOADS_BAUD_CHANGE - -/* FLASH */ -#undef CONFIG_SYS_FLASH_QUIET_TEST -#define CONFIG_SYS_FLASH_EMPTY_INFO -#define CONFIG_SYS_FLASH_BASE (0xA0000000) -#define CONFIG_SYS_MAX_FLASH_SECT 512 - -/* if you use all NOR Flash , you change dip-switch. Please see Manual. */ -#define CONFIG_SYS_MAX_FLASH_BANKS 1 -#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE } - -/* Timeout for Flash erase operations (in ms) */ -#define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) -/* Timeout for Flash write operations (in ms) */ -#define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) -/* Timeout for Flash set sector lock bit operations (in ms) */ -#define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) -/* Timeout for Flash clear lock bit operations (in ms) */ -#define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) - -/* - * Use hardware flash sectors protection instead - * of U-Boot software protection - */ -#undef CONFIG_SYS_DIRECT_FLASH_TFTP - -/* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ -#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE) -/* Monitor size */ -#define CONFIG_SYS_MONITOR_LEN (256 * 1024) -/* Size of DRAM reserved for malloc() use */ -#define CONFIG_SYS_MALLOC_LEN (256 * 1024) -#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) - -/* ENV setting */ -#define CONFIG_ENV_OVERWRITE 1 -#define CONFIG_ENV_SECT_SIZE (128 * 1024) -#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) -#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) -/* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ -#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) -#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) - -/* Board Clock */ -#define CONFIG_SYS_CLK_FREQ 41666666 -#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ - -#endif /* __ECOVEC_H */ |