diff options
Diffstat (limited to 'drivers/net/pfe_eth/pfe_eth.c')
| -rw-r--r-- | drivers/net/pfe_eth/pfe_eth.c | 297 |
1 files changed, 297 insertions, 0 deletions
diff --git a/drivers/net/pfe_eth/pfe_eth.c b/drivers/net/pfe_eth/pfe_eth.c new file mode 100644 index 00000000000..e6c6c8c9ab7 --- /dev/null +++ b/drivers/net/pfe_eth/pfe_eth.c @@ -0,0 +1,297 @@ +/* + * Copyright 2015-2016 Freescale Semiconductor, Inc. + * Copyright 2017 NXP + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +#include <common.h> +#include <dm.h> +#include <dm/platform_data/pfe_dm_eth.h> +#include <net.h> +#include <net/pfe_eth/pfe_eth.h> +#include <net/pfe_eth/pfe_mdio.h> + +struct gemac_s gem_info[] = { + /* PORT_0 configuration */ + { + /* GEMAC config */ + .gemac_speed = PFE_MAC_SPEED_1000M, + .gemac_duplex = DUPLEX_FULL, + + /* phy iface */ + .phy_address = CONFIG_PFE_EMAC1_PHY_ADDR, + .phy_mode = PHY_INTERFACE_MODE_SGMII, + }, + /* PORT_1 configuration */ + { + /* GEMAC config */ + .gemac_speed = PFE_MAC_SPEED_1000M, + .gemac_duplex = DUPLEX_FULL, + + /* phy iface */ + .phy_address = CONFIG_PFE_EMAC2_PHY_ADDR, + .phy_mode = PHY_INTERFACE_MODE_RGMII_TXID, + }, +}; + +static inline void pfe_gemac_enable(void *gemac_base) +{ + writel(readl(gemac_base + EMAC_ECNTRL_REG) | + EMAC_ECNTRL_ETHER_EN, gemac_base + EMAC_ECNTRL_REG); +} + +static inline void pfe_gemac_disable(void *gemac_base) +{ + writel(readl(gemac_base + EMAC_ECNTRL_REG) & + ~EMAC_ECNTRL_ETHER_EN, gemac_base + EMAC_ECNTRL_REG); +} + +static inline void pfe_gemac_set_speed(void *gemac_base, u32 speed) +{ + struct ccsr_scfg *scfg = (struct ccsr_scfg *)CONFIG_SYS_FSL_SCFG_ADDR; + u32 ecr = readl(gemac_base + EMAC_ECNTRL_REG) & ~EMAC_ECNTRL_SPEED; + u32 rcr = readl(gemac_base + EMAC_RCNTRL_REG) & ~EMAC_RCNTRL_RMII_10T; + u32 rgmii_pcr = in_be32(&scfg->rgmiipcr) & + ~(SCFG_RGMIIPCR_SETSP_1000M | SCFG_RGMIIPCR_SETSP_10M); + + if (speed == _1000BASET) { + ecr |= EMAC_ECNTRL_SPEED; + rgmii_pcr |= SCFG_RGMIIPCR_SETSP_1000M; + } else if (speed != _100BASET) { + rcr |= EMAC_RCNTRL_RMII_10T; + rgmii_pcr |= SCFG_RGMIIPCR_SETSP_10M; + } + + writel(ecr, gemac_base + EMAC_ECNTRL_REG); + out_be32(&scfg->rgmiipcr, rgmii_pcr | SCFG_RGMIIPCR_SETFD); + + /* remove loop back */ + rcr &= ~EMAC_RCNTRL_LOOP; + /* enable flow control */ + rcr |= EMAC_RCNTRL_FCE; + + /* Enable MII mode */ + rcr |= EMAC_RCNTRL_MII_MODE; + + writel(rcr, gemac_base + EMAC_RCNTRL_REG); + + /* Enable Tx full duplex */ + writel(readl(gemac_base + EMAC_TCNTRL_REG) | EMAC_TCNTRL_FDEN, + gemac_base + EMAC_TCNTRL_REG); +} + +static int pfe_eth_write_hwaddr(struct udevice *dev) +{ + struct pfe_eth_dev *priv = dev_get_priv(dev); + struct gemac_s *gem = priv->gem; + struct eth_pdata *pdata = dev_get_platdata(dev); + uchar *mac = pdata->enetaddr; + + writel((mac[0] << 24) + (mac[1] << 16) + (mac[2] << 8) + mac[3], + gem->gemac_base + EMAC_PHY_ADDR_LOW); + writel((mac[4] << 24) + (mac[5] << 16) + 0x8808, gem->gemac_base + + EMAC_PHY_ADDR_HIGH); + return 0; +} + +/** Stops or Disables GEMAC pointing to this eth iface. + * + * @param[in] edev Pointer to eth device structure. + * + * @return none + */ +static inline void pfe_eth_stop(struct udevice *dev) +{ + struct pfe_eth_dev *priv = dev_get_priv(dev); + + pfe_gemac_disable(priv->gem->gemac_base); + + gpi_disable(priv->gem->egpi_base); +} + +static int pfe_eth_start(struct udevice *dev) +{ + struct pfe_eth_dev *priv = dev_get_priv(dev); + struct gemac_s *gem = priv->gem; + int speed; + + /* set ethernet mac address */ + pfe_eth_write_hwaddr(dev); + + writel(EMAC_TFWR, gem->gemac_base + EMAC_TFWR_STR_FWD); + writel(EMAC_RX_SECTION_FULL_32, gem->gemac_base + EMAC_RX_SECTIOM_FULL); + writel(EMAC_TRUNC_FL_16K, gem->gemac_base + EMAC_TRUNC_FL); + writel(EMAC_TX_SECTION_EMPTY_30, gem->gemac_base + + EMAC_TX_SECTION_EMPTY); + writel(EMAC_MIBC_NO_CLR_NO_DIS, gem->gemac_base + + EMAC_MIB_CTRL_STS_REG); + +#ifdef CONFIG_PHYLIB + /* Start up the PHY */ + if (phy_startup(priv->phydev)) { + printf("Could not initialize PHY %s\n", + priv->phydev->dev->name); + return -1; + } + speed = priv->phydev->speed; + printf("Speed detected %x\n", speed); + if (priv->phydev->duplex == DUPLEX_HALF) { + printf("Half duplex not supported\n"); + return -1; + } +#endif + + pfe_gemac_set_speed(gem->gemac_base, speed); + + /* Enable GPI */ + gpi_enable(gem->egpi_base); + + /* Enable GEMAC */ + pfe_gemac_enable(gem->gemac_base); + + return 0; +} + +static int pfe_eth_send(struct udevice *dev, void *packet, int length) +{ + struct pfe_eth_dev *priv = (struct pfe_eth_dev *)dev->priv; + + int rc; + int i = 0; + + rc = pfe_send(priv->gemac_port, packet, length); + + if (rc < 0) { + printf("Tx Queue full\n"); + return rc; + } + + while (1) { + rc = pfe_tx_done(); + if (rc == 0) + break; + + udelay(100); + i++; + if (i == 30000) + printf("Tx timeout, send failed\n"); + break; + } + + return 0; +} + +static int pfe_eth_recv(struct udevice *dev, int flags, uchar **packetp) +{ + struct pfe_eth_dev *priv = dev_get_priv(dev); + uchar *pkt_buf; + int len; + int phy_port; + + len = pfe_recv(&pkt_buf, &phy_port); + + if (len == 0) + return -EAGAIN; /* no packet in rx */ + else if (len < 0) + return -EAGAIN; + + debug("Rx pkt: pkt_buf(0x%p), phy_port(%d), len(%d)\n", pkt_buf, + phy_port, len); + if (phy_port != priv->gemac_port) { + printf("Rx pkt not on expected port\n"); + return -EAGAIN; + } + + *packetp = pkt_buf; + + return len; +} + +static int pfe_eth_probe(struct udevice *dev) +{ + struct pfe_eth_dev *priv = dev_get_priv(dev); + struct pfe_ddr_address *pfe_addr; + struct pfe_eth_pdata *pdata = dev_get_platdata(dev); + int ret = 0; + static int init_done; + + if (!init_done) { + pfe_addr = (struct pfe_ddr_address *)malloc(sizeof + (struct pfe_ddr_address)); + if (!pfe_addr) + return -ENOMEM; + + pfe_addr->ddr_pfe_baseaddr = + (void *)pdata->pfe_ddr_addr.ddr_pfe_baseaddr; + pfe_addr->ddr_pfe_phys_baseaddr = + (unsigned long)pdata->pfe_ddr_addr.ddr_pfe_phys_baseaddr; + + debug("ddr_pfe_baseaddr: %p, ddr_pfe_phys_baseaddr: %08x\n", + pfe_addr->ddr_pfe_baseaddr, + (u32)pfe_addr->ddr_pfe_phys_baseaddr); + + ret = pfe_drv_init(pfe_addr); + if (ret) + return ret; + + init_pfe_scfg_dcfg_regs(); + init_done = 1; + } + + priv->gemac_port = pdata->pfe_eth_pdata_mac.phy_interface; + priv->gem = &gem_info[priv->gemac_port]; + priv->dev = dev; + + switch (priv->gemac_port) { + case EMAC_PORT_0: + default: + priv->gem->gemac_base = EMAC1_BASE_ADDR; + priv->gem->egpi_base = EGPI1_BASE_ADDR; + break; + case EMAC_PORT_1: + priv->gem->gemac_base = EMAC2_BASE_ADDR; + priv->gem->egpi_base = EGPI2_BASE_ADDR; + break; + } + + ret = pfe_eth_board_init(dev); + if (ret) + return ret; + +#if defined(CONFIG_PHYLIB) + ret = pfe_phy_configure(priv, pdata->pfe_eth_pdata_mac.phy_interface, + gem_info[priv->gemac_port].phy_address); +#endif + return ret; +} + +static int pfe_eth_bind(struct udevice *dev) +{ + struct pfe_eth_pdata *pdata = dev_get_platdata(dev); + char name[20]; + + sprintf(name, "pfe_eth%u", pdata->pfe_eth_pdata_mac.phy_interface); + + return device_set_name(dev, name); +} + +static const struct eth_ops pfe_eth_ops = { + .start = pfe_eth_start, + .send = pfe_eth_send, + .recv = pfe_eth_recv, + .free_pkt = pfe_eth_free_pkt, + .stop = pfe_eth_stop, + .write_hwaddr = pfe_eth_write_hwaddr, +}; + +U_BOOT_DRIVER(pfe_eth) = { + .name = "pfe_eth", + .id = UCLASS_ETH, + .bind = pfe_eth_bind, + .probe = pfe_eth_probe, + .remove = pfe_eth_remove, + .ops = &pfe_eth_ops, + .priv_auto_alloc_size = sizeof(struct pfe_eth_dev), + .platdata_auto_alloc_size = sizeof(struct pfe_eth_pdata) +}; |