diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.SBC8560 | 57 |
1 files changed, 0 insertions, 57 deletions
diff --git a/doc/README.SBC8560 b/doc/README.SBC8560 deleted file mode 100644 index c4b642236e9..00000000000 --- a/doc/README.SBC8560 +++ /dev/null @@ -1,57 +0,0 @@ -The port was tested on Wind River System Sbc8560 board -<www.windriver.com>. U-Boot was installed on the flash memory of the -CPU card (no the SODIMM). - -NOTE: Please configure uboot compile to the proper PCI frequency and -setup the appropriate DIP switch settings. - -SBC8560 board: - -Make sure boards switches are set to their appropriate conditions. -Refer to the Engineering Reference Guide ERG-00300-002. Of particular -importance are: 1) the settings for JP4 (JP4 1-3 and 2-4), which -select the on-board FLASH device (Intel 28F128Jx); 2) The settings -for the Clock SW9 (33 MHz or 66 MHz). - - Note: SW9 Settings: 66 MHz - 4:1 ratio CCB clocks:SYSCLK - 3:1 ration e500 Core:CCB - pos1 - on, pos2 - on, pos3 - off, pos4 - on, pos5 - off, pos6 - on - Note: SW9 Settings: 33 MHz - 8:1 ratio CCB clocks:SYSCLK - 3:1 ration e500 Core:CCB - pos1 - on, pos2 - on, pos3 - on, pos4 - off, pos5 - off, pos6 - on - - -Flashing the FLASH device with the "Wind River ICE": - -1) Properly connect and configure the Wind River ICE to the target - JTAG port. This includes running the SBC8560 register script. Make - sure target memory can be read and written. - -2) Build the u-boot image: - make distclean - make SBC8560_66_config or SBC8560_33_config - make CROSS_COMPILE=.../ELDK3.0/ppc_8xx-/ all - - Note: reference is made to the ELDK3.0 compiler. Further, it seems - the ppc_8xx compiler is required for the 85xx (no 85xx - designated compiler in ELDK3.0) - -3) Convert the uboot (.elf) file to a uboot.bin file (using - visionClick converter). The bin file should be converted from - fffc0000 to ffffffff - -4) Setup the Flash Utility (tools menu) for: - - Do a "dc clr" [visionClick] to load the default register settings - Determine the clock speed of the PCI bus and set SW9 accordingly - Note: the speed of the PCI bus defaults to the slowest PCI card - PlayBack the "default" register file for the SBC8560 - Select the uboot.bin file with zero bias - Select the initialize Target prior to programming - Select the V28F640Jx (8192 x 8) 1 device FLASH Algorithm - Select the erase base address from FFFC0000 to FFFFFFFF - Select the start address from 0 with size of 4000 - -5) Erase and Program |