diff options
Diffstat (limited to 'cmd/cmd_elf.c')
-rw-r--r-- | cmd/cmd_elf.c | 410 |
1 files changed, 410 insertions, 0 deletions
diff --git a/cmd/cmd_elf.c b/cmd/cmd_elf.c new file mode 100644 index 00000000000..5190cc6c0fe --- /dev/null +++ b/cmd/cmd_elf.c @@ -0,0 +1,410 @@ +/* + * Copyright (c) 2001 William L. Pitts + * All rights reserved. + * + * Redistribution and use in source and binary forms are freely + * permitted provided that the above copyright notice and this + * paragraph and the following disclaimer are duplicated in all + * such forms. + * + * This software is provided "AS IS" and without any express or + * implied warranties, including, without limitation, the implied + * warranties of merchantability and fitness for a particular + * purpose. + */ + +#include <common.h> +#include <command.h> +#include <elf.h> +#include <net.h> +#include <vxworks.h> +#ifdef CONFIG_X86 +#include <asm/e820.h> +#include <linux/linkage.h> +#endif + +/* + * A very simple elf loader, assumes the image is valid, returns the + * entry point address. + */ +static unsigned long load_elf_image_phdr(unsigned long addr) +{ + Elf32_Ehdr *ehdr; /* Elf header structure pointer */ + Elf32_Phdr *phdr; /* Program header structure pointer */ + int i; + + ehdr = (Elf32_Ehdr *)addr; + phdr = (Elf32_Phdr *)(addr + ehdr->e_phoff); + + /* Load each program header */ + for (i = 0; i < ehdr->e_phnum; ++i) { + void *dst = (void *)(uintptr_t)phdr->p_paddr; + void *src = (void *)addr + phdr->p_offset; + debug("Loading phdr %i to 0x%p (%i bytes)\n", + i, dst, phdr->p_filesz); + if (phdr->p_filesz) + memcpy(dst, src, phdr->p_filesz); + if (phdr->p_filesz != phdr->p_memsz) + memset(dst + phdr->p_filesz, 0x00, + phdr->p_memsz - phdr->p_filesz); + flush_cache((unsigned long)dst, phdr->p_filesz); + ++phdr; + } + + return ehdr->e_entry; +} + +static unsigned long load_elf_image_shdr(unsigned long addr) +{ + Elf32_Ehdr *ehdr; /* Elf header structure pointer */ + Elf32_Shdr *shdr; /* Section header structure pointer */ + unsigned char *strtab = 0; /* String table pointer */ + unsigned char *image; /* Binary image pointer */ + int i; /* Loop counter */ + + ehdr = (Elf32_Ehdr *)addr; + + /* Find the section header string table for output info */ + shdr = (Elf32_Shdr *)(addr + ehdr->e_shoff + + (ehdr->e_shstrndx * sizeof(Elf32_Shdr))); + + if (shdr->sh_type == SHT_STRTAB) + strtab = (unsigned char *)(addr + shdr->sh_offset); + + /* Load each appropriate section */ + for (i = 0; i < ehdr->e_shnum; ++i) { + shdr = (Elf32_Shdr *)(addr + ehdr->e_shoff + + (i * sizeof(Elf32_Shdr))); + + if (!(shdr->sh_flags & SHF_ALLOC) || + shdr->sh_addr == 0 || shdr->sh_size == 0) { + continue; + } + + if (strtab) { + debug("%sing %s @ 0x%08lx (%ld bytes)\n", + (shdr->sh_type == SHT_NOBITS) ? "Clear" : "Load", + &strtab[shdr->sh_name], + (unsigned long)shdr->sh_addr, + (long)shdr->sh_size); + } + + if (shdr->sh_type == SHT_NOBITS) { + memset((void *)(uintptr_t)shdr->sh_addr, 0, + shdr->sh_size); + } else { + image = (unsigned char *)addr + shdr->sh_offset; + memcpy((void *)(uintptr_t)shdr->sh_addr, + (const void *)image, shdr->sh_size); + } + flush_cache(shdr->sh_addr, shdr->sh_size); + } + + return ehdr->e_entry; +} + +/* Allow ports to override the default behavior */ +static unsigned long do_bootelf_exec(ulong (*entry)(int, char * const[]), + int argc, char * const argv[]) +{ + unsigned long ret; + + /* + * QNX images require the data cache is disabled. + * Data cache is already flushed, so just turn it off. + */ + int dcache = dcache_status(); + if (dcache) + dcache_disable(); + + /* + * pass address parameter as argv[0] (aka command name), + * and all remaining args + */ + ret = entry(argc, argv); + + if (dcache) + dcache_enable(); + + return ret; +} + +/* + * Determine if a valid ELF image exists at the given memory location. + * First look at the ELF header magic field, then make sure that it is + * executable. + */ +int valid_elf_image(unsigned long addr) +{ + Elf32_Ehdr *ehdr; /* Elf header structure pointer */ + + ehdr = (Elf32_Ehdr *)addr; + + if (!IS_ELF(*ehdr)) { + printf("## No elf image at address 0x%08lx\n", addr); + return 0; + } + + if (ehdr->e_type != ET_EXEC) { + printf("## Not a 32-bit elf image at address 0x%08lx\n", addr); + return 0; + } + + return 1; +} + +/* Interpreter command to boot an arbitrary ELF image from memory */ +int do_bootelf(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[]) +{ + unsigned long addr; /* Address of the ELF image */ + unsigned long rc; /* Return value from user code */ + char *sload, *saddr; + const char *ep = getenv("autostart"); + + int rcode = 0; + + sload = saddr = NULL; + if (argc == 3) { + sload = argv[1]; + saddr = argv[2]; + } else if (argc == 2) { + if (argv[1][0] == '-') + sload = argv[1]; + else + saddr = argv[1]; + } + + if (saddr) + addr = simple_strtoul(saddr, NULL, 16); + else + addr = load_addr; + + if (!valid_elf_image(addr)) + return 1; + + if (sload && sload[1] == 'p') + addr = load_elf_image_phdr(addr); + else + addr = load_elf_image_shdr(addr); + + if (ep && !strcmp(ep, "no")) + return rcode; + + printf("## Starting application at 0x%08lx ...\n", addr); + + /* + * pass address parameter as argv[0] (aka command name), + * and all remaining args + */ + rc = do_bootelf_exec((void *)addr, argc - 1, argv + 1); + if (rc != 0) + rcode = 1; + + printf("## Application terminated, rc = 0x%lx\n", rc); + + return rcode; +} + +/* + * Interpreter command to boot VxWorks from a memory image. The image can + * be either an ELF image or a raw binary. Will attempt to setup the + * bootline and other parameters correctly. + */ +int do_bootvx(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[]) +{ + unsigned long addr; /* Address of image */ + unsigned long bootaddr; /* Address to put the bootline */ + char *bootline; /* Text of the bootline */ + char *tmp; /* Temporary char pointer */ + char build_buf[128]; /* Buffer for building the bootline */ + int ptr = 0; +#ifdef CONFIG_X86 + struct e820info *info; + struct e820entry *data; +#endif + + /* + * Check the loadaddr variable. + * If we don't know where the image is then we're done. + */ + if (argc < 2) + addr = load_addr; + else + addr = simple_strtoul(argv[1], NULL, 16); + +#if defined(CONFIG_CMD_NET) + /* + * Check to see if we need to tftp the image ourselves + * before starting + */ + if ((argc == 2) && (strcmp(argv[1], "tftp") == 0)) { + if (net_loop(TFTPGET) <= 0) + return 1; + printf("Automatic boot of VxWorks image at address 0x%08lx ...\n", + addr); + } +#endif + + /* + * This should equate to + * NV_RAM_ADRS + NV_BOOT_OFFSET + NV_ENET_OFFSET + * from the VxWorks BSP header files. + * This will vary from board to board + */ +#if defined(CONFIG_WALNUT) + tmp = (char *)CONFIG_SYS_NVRAM_BASE_ADDR + 0x500; + eth_getenv_enetaddr("ethaddr", (uchar *)build_buf); + memcpy(tmp, &build_buf[3], 3); +#elif defined(CONFIG_SYS_VXWORKS_MAC_PTR) + tmp = (char *)CONFIG_SYS_VXWORKS_MAC_PTR; + eth_getenv_enetaddr("ethaddr", (uchar *)build_buf); + memcpy(tmp, build_buf, 6); +#else + puts("## Ethernet MAC address not copied to NV RAM\n"); +#endif + + /* + * Use bootaddr to find the location in memory that VxWorks + * will look for the bootline string. The default value is + * (LOCAL_MEM_LOCAL_ADRS + BOOT_LINE_OFFSET) as defined by + * VxWorks BSP. For example, on PowerPC it defaults to 0x4200. + */ + tmp = getenv("bootaddr"); + if (!tmp) { + printf("## VxWorks bootline address not specified\n"); + } else { + bootaddr = simple_strtoul(tmp, NULL, 16); + + /* + * Check to see if the bootline is defined in the 'bootargs' + * parameter. If it is not defined, we may be able to + * construct the info. + */ + bootline = getenv("bootargs"); + if (bootline) { + memcpy((void *)bootaddr, bootline, + max(strlen(bootline), (size_t)255)); + flush_cache(bootaddr, max(strlen(bootline), + (size_t)255)); + } else { + tmp = getenv("bootdev"); + if (tmp) { + strcpy(build_buf, tmp); + ptr = strlen(tmp); + } else + printf("## VxWorks boot device not specified\n"); + + tmp = getenv("bootfile"); + if (tmp) + ptr += sprintf(build_buf + ptr, + "host:%s ", tmp); + else + ptr += sprintf(build_buf + ptr, + "host:vxWorks "); + + /* + * The following parameters are only needed if 'bootdev' + * is an ethernet device, otherwise they are optional. + */ + tmp = getenv("ipaddr"); + if (tmp) { + ptr += sprintf(build_buf + ptr, "e=%s", tmp); + tmp = getenv("netmask"); + if (tmp) { + u32 mask = getenv_ip("netmask").s_addr; + ptr += sprintf(build_buf + ptr, + ":%08x ", ntohl(mask)); + } else { + ptr += sprintf(build_buf + ptr, " "); + } + } + + tmp = getenv("serverip"); + if (tmp) + ptr += sprintf(build_buf + ptr, "h=%s ", tmp); + + tmp = getenv("gatewayip"); + if (tmp) + ptr += sprintf(build_buf + ptr, "g=%s ", tmp); + + tmp = getenv("hostname"); + if (tmp) + ptr += sprintf(build_buf + ptr, "tn=%s ", tmp); + + tmp = getenv("othbootargs"); + if (tmp) { + strcpy(build_buf + ptr, tmp); + ptr += strlen(tmp); + } + + memcpy((void *)bootaddr, build_buf, + max(strlen(build_buf), (size_t)255)); + flush_cache(bootaddr, max(strlen(build_buf), + (size_t)255)); + } + + printf("## Using bootline (@ 0x%lx): %s\n", bootaddr, + (char *)bootaddr); + } + +#ifdef CONFIG_X86 + /* + * Since E820 information is critical to the kernel, if we don't + * specify these in the environments, use a default one. + */ + tmp = getenv("e820data"); + if (tmp) + data = (struct e820entry *)simple_strtoul(tmp, NULL, 16); + else + data = (struct e820entry *)VXWORKS_E820_DATA_ADDR; + tmp = getenv("e820info"); + if (tmp) + info = (struct e820info *)simple_strtoul(tmp, NULL, 16); + else + info = (struct e820info *)VXWORKS_E820_INFO_ADDR; + + memset(info, 0, sizeof(struct e820info)); + info->sign = E820_SIGNATURE; + info->entries = install_e820_map(E820MAX, data); + info->addr = (info->entries - 1) * sizeof(struct e820entry) + + VXWORKS_E820_DATA_ADDR; +#endif + + /* + * If the data at the load address is an elf image, then + * treat it like an elf image. Otherwise, assume that it is a + * binary image. + */ + if (valid_elf_image(addr)) + addr = load_elf_image_shdr(addr); + else + puts("## Not an ELF image, assuming binary\n"); + + printf("## Starting vxWorks at 0x%08lx ...\n", addr); + + dcache_disable(); +#ifdef CONFIG_X86 + /* VxWorks on x86 uses stack to pass parameters */ + ((asmlinkage void (*)(int))addr)(0); +#else + ((void (*)(int))addr)(0); +#endif + + puts("## vxWorks terminated\n"); + + return 1; +} + +U_BOOT_CMD( + bootelf, 3, 0, do_bootelf, + "Boot from an ELF image in memory", + "[-p|-s] [address]\n" + "\t- load ELF image at [address] via program headers (-p)\n" + "\t or via section headers (-s)" +); + +U_BOOT_CMD( + bootvx, 2, 0, do_bootvx, + "Boot vxWorks from an ELF image", + " [address] - load address of vxWorks ELF image." +); |