diff options
Diffstat (limited to 'board')
-rw-r--r-- | board/freescale/mpc837xemds/pci.c | 14 | ||||
-rw-r--r-- | board/keymile/common/common.c | 2 | ||||
-rw-r--r-- | board/keymile/kmeter1/kmeter1.c | 81 |
3 files changed, 71 insertions, 26 deletions
diff --git a/board/freescale/mpc837xemds/pci.c b/board/freescale/mpc837xemds/pci.c index 31116b31ce5..29de2e77f01 100644 --- a/board/freescale/mpc837xemds/pci.c +++ b/board/freescale/mpc837xemds/pci.c @@ -115,6 +115,13 @@ skip_pci: if (PARTID_NO_E(spridr) == SPR_8379) return; + if (pex2) + fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2, + FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); + else + fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX, + FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); + /* Configure the clock for PCIE controller */ clrsetbits_be32(&clk->sccr, SCCR_PCIEXP1CM | SCCR_PCIEXP2CM, SCCR_PCIEXP1CM_1 | SCCR_PCIEXP2CM_1); @@ -132,13 +139,6 @@ skip_pci: out_be32(&pcie_law[1].bar, CONFIG_SYS_PCIE2_BASE & LAWBAR_BAR); out_be32(&pcie_law[1].ar, LBLAWAR_EN | LBLAWAR_512MB); - if (pex2) - fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2, - FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); - else - fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX, - FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); - mpc83xx_pcie_init(pex2 ? 1 : 2, pcie_reg, 0); } diff --git a/board/keymile/common/common.c b/board/keymile/common/common.c index 13389508144..48ce613b7e2 100644 --- a/board/keymile/common/common.c +++ b/board/keymile/common/common.c @@ -318,7 +318,7 @@ int ivm_read_eeprom (void) if (buf != NULL) dev_addr = simple_strtoul ((char *)buf, NULL, 16); - if (eeprom_read (dev_addr, 0, i2c_buffer, CONFIG_SYS_IVM_EEPROM_MAX_LEN) != 0) { + if (i2c_read(dev_addr, 0, 1, i2c_buffer, CONFIG_SYS_IVM_EEPROM_MAX_LEN) != 0) { printf ("Error reading EEprom\n"); return -2; } diff --git a/board/keymile/kmeter1/kmeter1.c b/board/keymile/kmeter1/kmeter1.c index f04a57a9cc1..660d87b53b4 100644 --- a/board/keymile/kmeter1/kmeter1.c +++ b/board/keymile/kmeter1/kmeter1.c @@ -24,11 +24,14 @@ #include <miiphy.h> #include <asm/io.h> #include <asm/mmu.h> +#include <asm/processor.h> #include <pci.h> #include <libfdt.h> #include "../common/common.h" +extern void disable_addr_trans (void); +extern void enable_addr_trans (void); const qe_iop_conf_t qe_iop_conf_tab[] = { /* port pin dir open_drain assign */ @@ -59,27 +62,54 @@ const qe_iop_conf_t qe_iop_conf_tab[] = { {0, 0, 0, 0, QE_IOP_TAB_END}, }; +static int board_init_i2c_busses (void) +{ + I2C_MUX_DEVICE *dev = NULL; + uchar *buf; + + /* Set up the Bus for the DTTs */ + buf = (unsigned char *) getenv ("dtt_bus"); + if (buf != NULL) + dev = i2c_mux_ident_muxstring (buf); + if (dev == NULL) { + printf ("Error couldn't add Bus for DTT\n"); + printf ("please setup dtt_bus to where your\n"); + printf ("DTT is found.\n"); + } + return 0; +} + int board_early_init_r (void) { - void *reg = (void *)(CONFIG_SYS_IMMR + 0x14a8); - u32 val; + unsigned short svid; /* * Because of errata in the UCCs, we have to write to the reserved * registers to slow the clocks down. */ - val = in_be32 (reg); - /* UCC1 */ - val |= 0x00003000; - /* UCC2 */ - val |= 0x0c000000; - out_be32 (reg, val); + svid = SVR_REV(mfspr (SVR)); + switch (svid) { + case 0x0020: + setbits_be32((void *)(CONFIG_SYS_IMMR + 0x14a8), 0x0c003000); + break; + case 0x0021: + clrsetbits_be32((void *)(CONFIG_SYS_IMMR + 0x14ac), + 0x00000050, 0x000000a0); + break; + } /* enable the PHY on the PIGGY */ setbits (8, (void *)(CONFIG_SYS_PIGGY_BASE + 0x10003), 0x01); return 0; } +int misc_init_r (void) +{ + /* add board specific i2c busses */ + board_init_i2c_busses (); + return 0; +} + int fixed_sdram(void) { volatile immap_t *im = (immap_t *)CONFIG_SYS_IMMR; @@ -87,16 +117,7 @@ int fixed_sdram(void) u32 ddr_size; u32 ddr_size_log2; - msize = CONFIG_SYS_DDR_SIZE; - for (ddr_size = msize << 20, ddr_size_log2 = 0; - (ddr_size > 1); ddr_size = ddr_size >> 1, ddr_size_log2++) { - if (ddr_size & 1) - return -1; - } - - im->sysconf.ddrlaw[0].ar = - LAWAR_EN | ((ddr_size_log2 - 1) & LAWAR_SIZE); - + im->sysconf.ddrlaw[0].ar = LAWAR_EN | 0x1e; im->ddr.csbnds[0].csbnds = CONFIG_SYS_DDR_CS0_BNDS; im->ddr.cs_config[0] = CONFIG_SYS_DDR_CS0_CONFIG; im->ddr.timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0; @@ -112,6 +133,21 @@ int fixed_sdram(void) udelay (200); im->ddr.sdram_cfg |= SDRAM_CFG_MEM_EN; + msize = CONFIG_SYS_DDR_SIZE << 20; + disable_addr_trans (); + msize = get_ram_size (CONFIG_SYS_DDR_BASE, msize); + enable_addr_trans (); + msize /= (1024 * 1024); + if (CONFIG_SYS_DDR_SIZE != msize) { + for (ddr_size = msize << 20, ddr_size_log2 = 0; + (ddr_size > 1); ddr_size = ddr_size >> 1, ddr_size_log2++) + if (ddr_size & 1) + return -1; + im->sysconf.ddrlaw[0].ar = + LAWAR_EN | ((ddr_size_log2 - 1) & LAWAR_SIZE); + im->ddr.csbnds[0].csbnds = (((msize / 16) - 1) & 0xff); + } + return msize; } @@ -156,3 +192,12 @@ void ft_board_setup (void *blob, bd_t *bd) ft_cpu_setup (blob, bd); } #endif + +#if defined(CONFIG_HUSH_INIT_VAR) +extern int ivm_read_eeprom (void); +int hush_init_var (void) +{ + ivm_read_eeprom (); + return 0; +} +#endif |