diff options
Diffstat (limited to 'board/engicam/icorem6/README')
-rw-r--r-- | board/engicam/icorem6/README | 38 |
1 files changed, 38 insertions, 0 deletions
diff --git a/board/engicam/icorem6/README b/board/engicam/icorem6/README new file mode 100644 index 00000000000..12d1e2180c8 --- /dev/null +++ b/board/engicam/icorem6/README @@ -0,0 +1,38 @@ +How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit: +----------------------------------------------------------------------------- + +- Configure U-Boot for Engicam i.CoreM6 QDL: + +$ make mrproper +$ make icorem6qdl_mmc_defconfig + +- Build for i.CoreM6 DualLite/Solo + +$ make + +- Build for i.CoreM6 Quad/Dual + +$ make DEVICE_TREE=imx6q-icore + +This will generate the SPL image called SPL and the u-boot-dtb.img. + +- Flash the SPL image into the micro SD card: + +sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync + +- Flash the u-boot-dtb.img image into the micro SD card: + +sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync + +- Jumper settings: + +MMC Boot: JM3 Closed + +- Connect the Serial cable between the Starter Kit and the PC for the console. +(J28 is the Linux Serial console connector) + +- Insert the micro SD card in the board, power it up and U-Boot messages should +come up. + +- Note: For loading Linux on Quad/Dual modules set the dtb as + icorem6qdl> setenv fdt_file imx6q-icore.dtb |