diff options
Diffstat (limited to 'board/armltd/integrator/integrator.c')
| -rw-r--r-- | board/armltd/integrator/integrator.c | 63 |
1 files changed, 55 insertions, 8 deletions
diff --git a/board/armltd/integrator/integrator.c b/board/armltd/integrator/integrator.c index c8d2bc7bacb..a507c093aaa 100644 --- a/board/armltd/integrator/integrator.c +++ b/board/armltd/integrator/integrator.c @@ -35,6 +35,9 @@ #include <common.h> #include <netdev.h> +#include <asm/io.h> +#include "arm-ebi.h" +#include "integrator-sc.h" DECLARE_GLOBAL_DATA_PTR; @@ -55,6 +58,8 @@ void show_boot_progress(int progress) int board_init (void) { + u32 val; + /* arch number of Integrator Board */ #ifdef CONFIG_ARCH_CINTEGRATOR gd->bd->bi_arch_number = MACH_TYPE_CINTEGRATOR; @@ -72,6 +77,37 @@ extern void cm_remap(void); cm_remap(); /* remaps writeable memory to 0x00000000 */ #endif +#ifdef CONFIG_ARCH_CINTEGRATOR + /* + * Flash protection on the Integrator/CP is in a simple register + */ + val = readl(CP_FLASHPROG); + val |= (CP_FLASHPROG_FLVPPEN | CP_FLASHPROG_FLWREN); + writel(val, CP_FLASHPROG); +#else + /* + * The Integrator/AP has some special protection mechanisms + * for the external memories, first the External Bus Interface (EBI) + * then the system controller (SC). + * + * The system comes up with the flash memory non-writable and + * configuration locked. If we want U-Boot to be used for flash + * access we cannot have the flash memory locked. + */ + writel(EBI_UNLOCK_MAGIC, EBI_BASE + EBI_LOCK_REG); + val = readl(EBI_BASE + EBI_CSR1_REG); + val &= EBI_CSR_WREN_MASK; + val |= EBI_CSR_WREN_ENABLE; + writel(val, EBI_BASE + EBI_CSR1_REG); + writel(0, EBI_BASE + EBI_LOCK_REG); + + /* + * Set up the system controller to remove write protection from + * the flash memory and enable Vpp + */ + writel(SC_CTRL_FLASHVPP | SC_CTRL_FLASHWP, SC_CTRLS); +#endif + icache_enable (); return 0; @@ -86,21 +122,30 @@ int misc_init_r (void) return (0); } +/* + * The Integrator remaps the Flash memory to 0x00000000 and executes U-Boot + * from there, which means we cannot test the RAM underneath the ROM at this + * point. It will be unmapped later on, when we are executing from the + * relocated in RAM U-Boot. We simply assume that this RAM is usable if the + * RAM on higher addresses works fine. + */ +#define REMAPPED_FLASH_SZ 0x40000 + int dram_init (void) { gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE; #ifdef CONFIG_CM_SPD_DETECT { extern void dram_query(void); - unsigned long cm_reg_sdram; - unsigned long sdram_shift; + u32 cm_reg_sdram; + u32 sdram_shift; dram_query(); /* Assembler accesses to CM registers */ /* Queries the SPD values */ /* Obtain the SDRAM size from the CM SDRAM register */ - cm_reg_sdram = *(volatile ulong *)(CM_BASE + OS_SDRAM); + cm_reg_sdram = readl(CM_BASE + OS_SDRAM); /* Register SDRAM size * * 0xXXXXXXbbb000bb 16 MB @@ -110,16 +155,18 @@ extern void dram_query(void); * 0xXXXXXXbbb100bb 256 MB * */ - sdram_shift = ((cm_reg_sdram & 0x0000001C)/4)%4; - gd->bd->bi_dram[0].size = 0x01000000 << sdram_shift; - gd->ram_size = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE, + sdram_shift = ((cm_reg_sdram & 0x0000001C)/4)%4; + gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE + + REMAPPED_FLASH_SZ, 0x01000000 << sdram_shift); } #else - gd->bd->bi_dram[0].size = PHYS_SDRAM_1_SIZE; - gd->ram_size = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE, + gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE + + REMAPPED_FLASH_SZ, PHYS_SDRAM_1_SIZE); #endif /* CM_SPD_DETECT */ + /* We only have one bank of RAM, set it to whatever was detected */ + gd->bd->bi_dram[0].size = gd->ram_size; return 0; } |