diff options
Diffstat (limited to 'arch/arm/cpu/armv7/tegra-common')
-rw-r--r-- | arch/arm/cpu/armv7/tegra-common/ap20.c | 35 |
1 files changed, 33 insertions, 2 deletions
diff --git a/arch/arm/cpu/armv7/tegra-common/ap20.c b/arch/arm/cpu/armv7/tegra-common/ap20.c index fb836963c8f..40e8f36cfff 100644 --- a/arch/arm/cpu/armv7/tegra-common/ap20.c +++ b/arch/arm/cpu/armv7/tegra-common/ap20.c @@ -65,7 +65,7 @@ static struct clk_pll_table tegra_pll_x_table[TEGRA_SOC_COUNT] { 600, 13, 0, 12}, }, - /* T30: 1.5 GHz with slower PLLP */ + /* T30: 1.5 GHz with slower (216MHz) PLLP */ {{ 0xd8, 13, 1, 8}, { 0xb4, 22, 1, 4}, { 0x1b0, 12, 1, 8}, @@ -119,6 +119,26 @@ int ap20_cpu_is_cortexa9(void) return id == (PG_UP_TAG_0_PID_CPU & 0xff); } +#if defined(CONFIG_SYS_PLLP_BASE_IS_408MHZ) +static void adjust_pllp_out_freqs(void) +{ + struct clk_rst_ctlr *clkrst = (struct clk_rst_ctlr *)NV_PA_CLK_RST_BASE; + struct clk_pll *pll = &clkrst->crc_pll[CLOCK_ID_PERIPH]; + u32 reg; + + /* Set T30 PLLP_OUT1, 2, 3 & 4 freqs to 9.6, 48, 102 & 204MHz */ + reg = readl(&pll->pll_out); /* OUTA, contains OUT2 / OUT1 */ + reg |= (IN_408_OUT_48_DIVISOR << PLLP_OUT2_RATIO) | PLLP_OUT2_OVR + | (IN_408_OUT_9_6_DIVISOR << PLLP_OUT1_RATIO) | PLLP_OUT1_OVR; + writel(reg, &pll->pll_out); + + reg = readl(&pll->pll_out_b); /* OUTB, contains OUT4 / OUT3 */ + reg |= (IN_408_OUT_204_DIVISOR << PLLP_OUT4_RATIO) | PLLP_OUT4_OVR + | (IN_408_OUT_102_DIVISOR << PLLP_OUT3_RATIO) | PLLP_OUT3_OVR; + writel(reg, &pll->pll_out_b); +} +#endif + static int pllx_set_rate(struct clk_pll *pll , u32 divn, u32 divm, u32 divp, u32 cpcon) { @@ -168,6 +188,9 @@ void ap20_init_pllx(int slow) /* set pllx */ sel = &tegra_pll_x_table[chip_type][osc]; pllx_set_rate(pll, sel->n, sel->m, sel->p, sel->cpcon); +#if defined(CONFIG_SYS_PLLP_BASE_IS_408MHZ) + adjust_pllp_out_freqs(); +#endif } static void enable_cpu_clock(int enable) @@ -340,7 +363,7 @@ void t30_init_clocks(void) clrbits_le32(flow->control, 1 << 0); /* - * Switch system clock to PLLP_out 4 (108 MHz) MHz, AVP will now run + * Switch system clock to PLLP_OUT4 (108 MHz), AVP will now run * at 108 MHz. This is glitch free as only the source is changed, no * special precaution needed. */ @@ -399,7 +422,15 @@ static void clock_enable_coresight(int enable) * Set PLLP_OUT0 [bits31:30 = 00], and use a 7.1 divisor * (bits 7:0), so 00000001b == 1.5 (n+1 + .5) */ +#if defined(CONFIG_SYS_PLLP_BASE_IS_408MHZ) + /* + * Clock divider request for 204MHz would setup CSITE clock as + * 144MHz for PLLP base 216MHz and 204MHz for PLLP base 408MHz + */ + src = CLK_DIVIDER(NVBL_PLLP_KHZ, 204000); +#else src = CLK_DIVIDER(NVBL_PLLP_KHZ, 144000); +#endif clock_ll_set_source_divisor(PERIPH_ID_CSI, 0, src); /* Unlock the CPU CoreSight interfaces */ |