mmc: add the MMC_CLK_ENABLE/DISABLE macro in mmc.h

mmc_set_clock() function has the disable argument as bool type.
When mmc_set_clock is called, it might be passed to "true" or "false".
But it's too confusion whether clock is enabled or disabled with only
"true" and "false".
To prevent the confusion, replace to MMC_CLK_ENABLE/DISABLE macro from
true/false.

Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com>

3 files changed, 12 insertions, 10 deletions

diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
index 1a006fa95f2..4528345c676 100644
--- a/drivers/mmc/fsl_esdhc.c
+++ b/drivers/mmc/fsl_esdhc.c
@@ -982,7 +982,7 @@ static int esdhc_init_common(struct fsl_esdhc_priv *priv, struct mmc *mmc)
 #endif
 
 	/* Set the initial clock speed */
-	mmc_set_clock(mmc, 400000, false);
+	mmc_set_clock(mmc, 400000, MMC_CLK_ENABLE);
 
 	/* Disable the BRR and BWR bits in IRQSTAT */
 	esdhc_clrbits32(&regs->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);
diff --git a/drivers/mmc/meson_gx_mmc.c b/drivers/mmc/meson_gx_mmc.c
index 0aea4770c5b..332f1e12a58 100644
--- a/drivers/mmc/meson_gx_mmc.c
+++ b/drivers/mmc/meson_gx_mmc.c
@@ -252,7 +252,7 @@ static int meson_mmc_probe(struct udevice *dev)
 	mmc->priv = pdata;
 	upriv->mmc = mmc;
 
-	mmc_set_clock(mmc, cfg->f_min, false);
+	mmc_set_clock(mmc, cfg->f_min, MMC_CLK_ENABLE);
 
 	/* reset all status bits */
 	meson_write(mmc, STATUS_MASK, MESON_SD_EMMC_STATUS);
diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
index 01a02fba63f..29971a5047c 100644
--- a/drivers/mmc/mmc.c
+++ b/drivers/mmc/mmc.c
@@ -529,7 +529,7 @@ static int mmc_switch_voltage(struct mmc *mmc, int signal_voltage)
 	 * During a signal voltage level switch, the clock must be gated
 	 * for 5 ms according to the SD spec
 	 */
-	mmc_set_clock(mmc, mmc->clock, true);
+	mmc_set_clock(mmc, mmc->clock, MMC_CLK_DISABLE);
 
 	err = mmc_set_signal_voltage(mmc, signal_voltage);
 	if (err)
@@ -537,7 +537,7 @@ static int mmc_switch_voltage(struct mmc *mmc, int signal_voltage)
 
 	/* Keep clock gated for at least 10 ms, though spec only says 5 ms */
 	mdelay(10);
-	mmc_set_clock(mmc, mmc->clock, false);
+	mmc_set_clock(mmc, mmc->clock, MMC_CLK_ENABLE);
 
 	/*
 	 * Failure to switch is indicated by the card holding
@@ -1672,7 +1672,8 @@ static int sd_select_mode_and_width(struct mmc *mmc, uint card_caps)
 
 				/* configure the bus mode (host) */
 				mmc_select_mode(mmc, mwt->mode);
-				mmc_set_clock(mmc, mmc->tran_speed, false);
+				mmc_set_clock(mmc, mmc->tran_speed,
+						MMC_CLK_ENABLE);
 
 #ifdef MMC_SUPPORTS_TUNING
 				/* execute tuning if needed */
@@ -1697,7 +1698,8 @@ static int sd_select_mode_and_width(struct mmc *mmc, uint card_caps)
 error:
 				/* revert to a safer bus speed */
 				mmc_select_mode(mmc, SD_LEGACY);
-				mmc_set_clock(mmc, mmc->tran_speed, false);
+				mmc_set_clock(mmc, mmc->tran_speed,
+						MMC_CLK_ENABLE);
 			}
 		}
 	}
@@ -1858,7 +1860,7 @@ static int mmc_select_mode_and_width(struct mmc *mmc, uint card_caps)
 		return -ENOTSUPP;
 	}
 
-	mmc_set_clock(mmc, mmc->legacy_speed, false);
+	mmc_set_clock(mmc, mmc->legacy_speed, MMC_CLK_ENABLE);
 
 	for_each_mmc_mode_by_pref(card_caps, mwt) {
 		for_each_supported_width(card_caps & mwt->widths,
@@ -1901,7 +1903,7 @@ static int mmc_select_mode_and_width(struct mmc *mmc, uint card_caps)
 
 			/* configure the bus mode (host) */
 			mmc_select_mode(mmc, mwt->mode);
-			mmc_set_clock(mmc, mmc->tran_speed, false);
+			mmc_set_clock(mmc, mmc->tran_speed, MMC_CLK_ENABLE);
 #ifdef MMC_SUPPORTS_TUNING
 
 			/* execute tuning if needed */
@@ -2426,7 +2428,7 @@ static void mmc_set_initial_state(struct mmc *mmc)
 
 	mmc_select_mode(mmc, MMC_LEGACY);
 	mmc_set_bus_width(mmc, 1);
-	mmc_set_clock(mmc, 0, false);
+	mmc_set_clock(mmc, 0, MMC_CLK_ENABLE);
 }
 
 static int mmc_power_on(struct mmc *mmc)
@@ -2446,7 +2448,7 @@ static int mmc_power_on(struct mmc *mmc)
 
 static int mmc_power_off(struct mmc *mmc)
 {
-	mmc_set_clock(mmc, 0, true);
+	mmc_set_clock(mmc, 0, MMC_CLK_DISABLE);
 #if CONFIG_IS_ENABLED(DM_MMC) && CONFIG_IS_ENABLED(DM_REGULATOR)
 	if (mmc->vmmc_supply) {
 		int ret = regulator_set_enable(mmc->vmmc_supply, false);