Merge branch 'master' of git://git.denx.de/u-boot-x86

2 files changed, 31 insertions, 2 deletions

diff --git a/doc/README.x86 b/doc/README.x86
index 36aaef011de..6d9cb10edc8 100644
--- a/doc/README.x86
+++ b/doc/README.x86
@@ -706,7 +706,7 @@ the board, then you can use post_code() calls from C or assembler to monitor
 boot progress. This can be good for debugging.
 
 If not, you can try to get serial working as early as possible. The early
-debug serial port may be useful here. See setup_early_uart() for an example.
+debug serial port may be useful here. See setup_internal_uart() for an example.
 
 During the U-Boot porting, one of the important steps is to write correct PIRQ
 routing information in the board device tree. Without it, device drivers in the
diff --git a/doc/device-tree-bindings/misc/intel,baytrail-fsp.txt b/doc/device-tree-bindings/misc/intel,baytrail-fsp.txt
index b44b5b5431f..07fa46ef7ef 100644
--- a/doc/device-tree-bindings/misc/intel,baytrail-fsp.txt
+++ b/doc/device-tree-bindings/misc/intel,baytrail-fsp.txt
@@ -74,12 +74,41 @@ discovered by the FSP and used to setup main memory.
 
 	# Integer properties:
 
-	- fsp,dram-speed
+	- fsp,dram-speed:
+	  0x0: "800 MHz"
+	  0x1: "1066 MHz"
+	  0x2: "1333 MHz"
+	  0x3: "1600 MHz"
+
 	- fsp,dram-type
+	  0x0: "DDR3"
+	  0x1: "DDR3L"
+	  0x2: "DDR3U"
+	  0x4: "LPDDR2"
+	  0x5: "LPDDR3"
+	  0x6: "DDR4"
+
 	- fsp,dimm-width
+	  0x0: "x8"
+	  0x1: "x16"
+	  0x2: "x32"
+
 	- fsp,dimm-density
+	  0x0: "1 Gbit"
+	  0x1: "2 Gbit"
+	  0x2: "4 Gbit"
+	  0x3: "8 Gbit"
+
 	- fsp,dimm-bus-width
+	  0x0: "8 bits"
+	  0x1: "16 bits"
+	  0x2: "32 bits"
+	  0x3: "64 bits"
+
 	- fsp,dimm-sides
+	  0x0: "1 rank"
+	  0x1: "2 ranks"
+
 	- fsp,dimm-tcl
 	- fsp,dimm-trpt-rcd
 	- fsp,dimm-twr