imx7: SPI: add suport for SPI flash in mikroBUS slot

Enable the escpi3 nets attached to the mikroBUS slot
on the i.MX7 Sabre evalution board. Also enble the SPI flash
commands to work with the "flash click" board.

This is V2 of this patch with changes recommended by the maintainer

CC: Jagan Teki <jteki@openedev.com>

1 files changed, 24 insertions, 0 deletions

diff --git a/board/freescale/mx7dsabresd/mx7dsabresd.c b/board/freescale/mx7dsabresd/mx7dsabresd.c
index b9365445e8..6ccdd4b33b 100644
--- a/board/freescale/mx7dsabresd/mx7dsabresd.c
+++ b/board/freescale/mx7dsabresd/mx7dsabresd.c
@@ -50,6 +50,9 @@ DECLARE_GLOBAL_DATA_PTR;
 
 #define NAND_PAD_CTRL (PAD_CTL_DSE_3P3V_49OHM | PAD_CTL_SRE_SLOW | PAD_CTL_HYS)
 
+#define SPI_PAD_CTRL \
+  (PAD_CTL_HYS | PAD_CTL_DSE_3P3V_49OHM | PAD_CTL_SRE_FAST)
+
 #define NAND_PAD_READY0_CTRL (PAD_CTL_DSE_3P3V_49OHM | PAD_CTL_PUS_PU5KOHM)
 #ifdef CONFIG_SYS_I2C_MXC
 #define PC MUX_PAD_CTRL(I2C_PAD_CTRL)
@@ -68,6 +71,23 @@ static struct i2c_pads_info i2c_pad_info1 = {
 };
 #endif
 
+static iomux_v3_cfg_t const ecspi3_pads[] = {
+    MX7D_PAD_SAI2_RX_DATA__ECSPI3_SCLK | MUX_PAD_CTRL(SPI_PAD_CTRL),
+    MX7D_PAD_SAI2_TX_SYNC__ECSPI3_MISO | MUX_PAD_CTRL(SPI_PAD_CTRL),
+    MX7D_PAD_SAI2_TX_BCLK__ECSPI3_MOSI | MUX_PAD_CTRL(SPI_PAD_CTRL),
+    MX7D_PAD_SAI2_TX_DATA__GPIO6_IO22 | MUX_PAD_CTRL(NO_PAD_CTRL),
+};
+
+int board_spi_cs_gpio(unsigned bus, unsigned cs)
+{
+         return (bus == 2 && cs == 0) ? (IMX_GPIO_NR(6, 22)) : -1;
+}
+
+static void setup_spi(void)
+{
+         imx_iomux_v3_setup_multiple_pads(ecspi3_pads, ARRAY_SIZE(ecspi3_pads));
+}
+
 int dram_init(void)
 {
 	gd->ram_size = PHYS_SDRAM_SIZE;
@@ -553,6 +573,10 @@ int board_init(void)
 	board_qspi_init();
 #endif
 
+#ifdef CONFIG_MXC_SPI
+       setup_spi();
+#endif
+
 	return 0;
 }