diff options
Diffstat (limited to 'Documentation/devicetree/bindings/gpio/gpio-restart.txt')
-rw-r--r-- | Documentation/devicetree/bindings/gpio/gpio-restart.txt | 54 |
1 files changed, 0 insertions, 54 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-restart.txt b/Documentation/devicetree/bindings/gpio/gpio-restart.txt deleted file mode 100644 index af3701bc15c4..000000000000 --- a/Documentation/devicetree/bindings/gpio/gpio-restart.txt +++ /dev/null @@ -1,54 +0,0 @@ -Drive a GPIO line that can be used to restart the system from a restart -handler. - -This binding supports level and edge triggered reset. At driver load -time, the driver will request the given gpio line and install a restart -handler. If the optional properties 'open-source' is not found, the GPIO line -will be driven in the inactive state. Otherwise its not driven until -the restart is initiated. - -When the system is restarted, the restart handler will be invoked in -priority order. The gpio is configured as an output, and driven active, -triggering a level triggered reset condition. This will also cause an -inactive->active edge condition, triggering positive edge triggered -reset. After a delay specified by active-delay, the GPIO is set to -inactive, thus causing an active->inactive edge, triggering negative edge -triggered reset. After a delay specified by inactive-delay, the GPIO -is driven active again. After a delay specified by wait-delay, the -restart handler completes allowing other restart handlers to be attempted. - -Required properties: -- compatible : should be "gpio-restart". -- gpios : The GPIO to set high/low, see "gpios property" in - Documentation/devicetree/bindings/gpio/gpio.txt. If the pin should be - low to reset the board set it to "Active Low", otherwise set - gpio to "Active High". - -Optional properties: -- open-source : Treat the GPIO as being open source and defer driving - it to when the restart is initiated. If this optional property is not - specified, the GPIO is initialized as an output in its inactive state. -- priority : A priority ranging from 0 to 255 (default 128) according to - the following guidelines: - 0: Restart handler of last resort, with limited restart - capabilities - 128: Default restart handler; use if no other restart handler is - expected to be available, and/or if restart functionality is - sufficient to restart the entire system - 255: Highest priority restart handler, will preempt all other - restart handlers -- active-delay: Delay (default 100) to wait after driving gpio active [ms] -- inactive-delay: Delay (default 100) to wait after driving gpio inactive [ms] -- wait-delay: Delay (default 3000) to wait after completing restart - sequence [ms] - -Examples: - -gpio-restart { - compatible = "gpio-restart"; - gpios = <&gpio 4 0>; - priority = <128>; - active-delay = <100>; - inactive-delay = <100>; - wait-delay = <3000>; -}; |