ixgbe:add support for a new 82599 10G Base-T device

This adds support for a new copper device for 82599, device id 0x151c.
This 82599 10GBase-T device uses the PHY's internal temperature sensor
to guard against over-temp conditions. In this scenario the PHY will be
put in a low power mode and link will no longer be able to transmit or
receive any data. When this occurs, the over-temp interrupt is latched
and driver logs this error message. A HW reset or power cycle is
required to clear this status.

Signed-off-by: Mallikarjuna R Chilakala <mallikarjuna.chilakala@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 30 insertions, 0 deletions

diff --git a/drivers/net/ixgbe/ixgbe_phy.c b/drivers/net/ixgbe/ixgbe_phy.c
index 22d21af14783..09e1911ff510 100644
--- a/drivers/net/ixgbe/ixgbe_phy.c
+++ b/drivers/net/ixgbe/ixgbe_phy.c
@@ -135,6 +135,11 @@ static enum ixgbe_phy_type ixgbe_get_phy_type_from_id(u32 phy_id)
  **/
 s32 ixgbe_reset_phy_generic(struct ixgbe_hw *hw)
 {
+	/* Don't reset PHY if it's shut down due to overtemp. */
+	if (!hw->phy.reset_if_overtemp &&
+	    (IXGBE_ERR_OVERTEMP == hw->phy.ops.check_overtemp(hw)))
+		return 0;
+
 	/*
 	 * Perform soft PHY reset to the PHY_XS.
 	 * This will cause a soft reset to the PHY
@@ -1345,3 +1350,28 @@ s32 ixgbe_get_phy_firmware_version_tnx(struct ixgbe_hw *hw,
 	return status;
 }
 
+/**
+ *  ixgbe_tn_check_overtemp - Checks if an overtemp occured.
+ *  @hw: pointer to hardware structure
+ *
+ *  Checks if the LASI temp alarm status was triggered due to overtemp
+ **/
+s32 ixgbe_tn_check_overtemp(struct ixgbe_hw *hw)
+{
+	s32 status = 0;
+	u16 phy_data = 0;
+
+	if (hw->device_id != IXGBE_DEV_ID_82599_T3_LOM)
+		goto out;
+
+	/* Check that the LASI temp alarm status was triggered */
+	hw->phy.ops.read_reg(hw, IXGBE_TN_LASI_STATUS_REG,
+	                     MDIO_MMD_PMAPMD, &phy_data);
+
+	if (!(phy_data & IXGBE_TN_LASI_STATUS_TEMP_ALARM))
+		goto out;
+
+	status = IXGBE_ERR_OVERTEMP;
+out:
+	return status;
+}