stmmac: dwmac-sti: Pass sysconfig register offset via syscon dt property.

Based on Arnds review comments here https://lkml.org/lkml/2014/11/13/161,
we should not be mixing address spaces in the reg property like this driver
currently does. This patch updates the driver, dt docs and also the existing
dt nodes to pass the sysconfig offset in the syscon dt property.

This patch breaks DT compatibility! But this platform is considered WIP,
and is only used by a few developers who are upstreaming support for it.
This change has been done as a single atomic commit to ensure it is
bisectable.

Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Reviewed-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 9 deletions

diff --git a/Documentation/devicetree/bindings/net/sti-dwmac.txt b/Documentation/devicetree/bindings/net/sti-dwmac.txt
index 6762a6b5da7e..d05c1e1fd9b6 100644
--- a/Documentation/devicetree/bindings/net/sti-dwmac.txt
+++ b/Documentation/devicetree/bindings/net/sti-dwmac.txt
@@ -9,14 +9,10 @@ The device node has following properties.
 Required properties:
  - compatible	: Can be "st,stih415-dwmac", "st,stih416-dwmac",
    "st,stih407-dwmac", "st,stid127-dwmac".
- - reg : Offset of the glue configuration register map in system
-   configuration regmap pointed by st,syscon property and size.
- - st,syscon : Should be phandle to system configuration node which
-   encompases this glue registers.
+ - st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
+   encompases the glue register, and the offset of the control register.
  - st,gmac_en: this is to enable the gmac into a dedicated sysctl control
    register available on STiH407 SoC.
- - sti-ethconf: this is the gmac glue logic register to enable the GMAC,
-   select among the different modes and program the clk retiming.
  - pinctrl-0: pin-control for all the MII mode supported.
 
 Optional properties:
@@ -40,10 +36,10 @@ ethernet0: dwmac@9630000 {
 	device_type = "network";
 	status = "disabled";
 	compatible = "st,stih407-dwmac", "snps,dwmac", "snps,dwmac-3.710";
-	reg = <0x9630000 0x8000>, <0x80 0x4>;
-	reg-names = "stmmaceth", "sti-ethconf";
+	reg = <0x9630000 0x8000>;
+	reg-names = "stmmaceth";
 
-	st,syscon = <&syscfg_sbc_reg>;
+	st,syscon = <&syscfg_sbc_reg 0x80>;
 	st,gmac_en;
 	resets = <&softreset STIH407_ETH1_SOFTRESET>;
 	reset-names = "stmmaceth";