diff options
Diffstat (limited to 'board/freescale/imx8qm_mek/imx8qm_mek.c')
| -rw-r--r-- | board/freescale/imx8qm_mek/imx8qm_mek.c | 18 |
1 files changed, 0 insertions, 18 deletions
diff --git a/board/freescale/imx8qm_mek/imx8qm_mek.c b/board/freescale/imx8qm_mek/imx8qm_mek.c index a51827b587..1d5648b2a3 100644 --- a/board/freescale/imx8qm_mek/imx8qm_mek.c +++ b/board/freescale/imx8qm_mek/imx8qm_mek.c @@ -163,24 +163,6 @@ int board_eth_init(bd_t *bis) int board_phy_config(struct phy_device *phydev) { -#ifdef CONFIG_FEC_ENABLE_MAX7322 - uint8_t value; - - /* This is needed to drive the pads to 1.8V instead of 1.5V */ - i2c_set_bus_num(CONFIG_MAX7322_I2C_BUS); - - if (!i2c_probe(CONFIG_MAX7322_I2C_ADDR)) { - /* Write 0x1 to enable O0 output, this device has no addr */ - /* hence addr length is 0 */ - value = 0x1; - if (i2c_write(CONFIG_MAX7322_I2C_ADDR, 0, 0, &value, 1)) - printf("MAX7322 write failed\n"); - } else { - printf("MAX7322 Not found\n"); - } - mdelay(1); -#endif - phy_write(phydev, MDIO_DEVAD_NONE, 0x1d, 0x1f); phy_write(phydev, MDIO_DEVAD_NONE, 0x1e, 0x8); |