diff options
| -rw-r--r-- | board/freescale/imx8qm_mek/imx8qm_mek.c | 18 | ||||
| -rw-r--r-- | include/configs/imx8qm_mek.h | 7 |
2 files changed, 0 insertions, 25 deletions
diff --git a/board/freescale/imx8qm_mek/imx8qm_mek.c b/board/freescale/imx8qm_mek/imx8qm_mek.c index a51827b587..1d5648b2a3 100644 --- a/board/freescale/imx8qm_mek/imx8qm_mek.c +++ b/board/freescale/imx8qm_mek/imx8qm_mek.c @@ -163,24 +163,6 @@ int board_eth_init(bd_t *bis) int board_phy_config(struct phy_device *phydev) { -#ifdef CONFIG_FEC_ENABLE_MAX7322 - uint8_t value; - - /* This is needed to drive the pads to 1.8V instead of 1.5V */ - i2c_set_bus_num(CONFIG_MAX7322_I2C_BUS); - - if (!i2c_probe(CONFIG_MAX7322_I2C_ADDR)) { - /* Write 0x1 to enable O0 output, this device has no addr */ - /* hence addr length is 0 */ - value = 0x1; - if (i2c_write(CONFIG_MAX7322_I2C_ADDR, 0, 0, &value, 1)) - printf("MAX7322 write failed\n"); - } else { - printf("MAX7322 Not found\n"); - } - mdelay(1); -#endif - phy_write(phydev, MDIO_DEVAD_NONE, 0x1d, 0x1f); phy_write(phydev, MDIO_DEVAD_NONE, 0x1e, 0x8); diff --git a/include/configs/imx8qm_mek.h b/include/configs/imx8qm_mek.h index a4037a8dce..8fdcf50f52 100644 --- a/include/configs/imx8qm_mek.h +++ b/include/configs/imx8qm_mek.h @@ -81,19 +81,12 @@ #elif (CONFIG_FEC_ENET_DEV == 1) #define IMX_FEC_BASE 0x5B050000 #define CONFIG_FEC_MXC_PHYADDR 0x1 -#define CONFIG_FEC_ENABLE_MAX7322 #define CONFIG_ETHPRIME "eth1" #endif /* ENET0 MDIO are shared */ #define CONFIG_FEC_MXC_MDIO_BASE 0x5B040000 -/* MAX7322 */ -#ifdef CONFIG_FEC_ENABLE_MAX7322 -#define CONFIG_MAX7322_I2C_ADDR 0x68 -#define CONFIG_MAX7322_I2C_BUS 0 /* I2C0 */ -#endif - /* Boot M4 */ #define M4_BOOT_ENV \ "m4_0_image=m4_0.bin\0" \ |